ejector pins的意思

ejector pins中文翻譯：

出坯桿，起模桿；推頂桿，推釘

相似詞語短語

detector vans───探測車

ejector seats───彈射座椅

center pins───中心軸；[機]中心銷

ejector seat───彈射座椅

ejectors───n.[機]噴射器；推出器；驅逐者（ejector的復數）

regulator pins───快慢針

pectoral fins───[魚]胸鰭

rejection slips───退稿通知

Erector Sets───安裝裝置

雙語使用場景

Suitable sizes of push-back pins may be selected from a standard ejector pin range.───回程桿的合適尺寸可以在標準的頂桿范圍內選擇。

As a result, a mould with double stripper mechanism was needed, that is to say, there were levers and ejector pins on the stationary mould half and ejector pipes on the moving mould half.───為保證順利脫模， 模具設計采用了雙脫模機構，即定模采用杠桿、推桿頂出機構，動模采用推管二級頂出機構。

Ejector guide pins installation.───頂針導柱的安裝。

Blanking and piercing punches must contain slug ejector pins wherever possible.───下料和刺破的沖頭需有備件隨時更換

During stage one, the moulding and attached peg are ejected by the ejector pins as shown at 'b'.───在第一階段，塑件和附加的柱銷被頂桿頂出，圖“b”。

No ejector pins or sleeves under slides without positive mechanical return system.───沒有有效的機械復位系統，不允許做頂針和司筒。

The plastic parts are ejected by the ejector pins and angular ejector pins.───噴出的塑料部件的頂針和角頂針。

In order to perform an effective ejection, ejector pins should act against walls, ribs, bosses or any rigid area of the part.───為了進行有效的彈射，頂針應采取行動對付墻壁，肋骨，老板或任何部分剛性地區。

Design of Compression Mould with Multi-cavity, Vertical Parting and Secondary Ejector Pins───垂直分型二級推件多型腔壓模設計

英語使用場景

Introducting a gear billet forming die carrier structure used on friction press for no fash forming discusses die carrier guide , ejector pins and main elements selection of materials, heat treatment.

An ejector pin (4) is provided immediately below the peg, in addition to the normal ejector system, which in this example is also by means of ejector pins (5).