青年中文phase current的意思
phase current中文翻譯：
相流，[電]相電流
相似詞語短語
air current───[流]氣流
dark current───[電子]暗電流
palaeocurrent───[海洋]古洋流
percurrent───及頂的
photocurrent───n.[電子]光電流
white currant───白加侖子
Agulhas current───阿古拉斯海流（沿著非洲南部東岸向西南流的印度洋洋流）
雙語使用場景
Three - phase current should be used for large motors.───大型電機應該使用 三相 電流.
Three - phase current protection relay is one of the important forms of protection.───三 段式 電流保護是繼電保護測試儀中一種重要的保護形式.
Effective methods are employed in rotor position computing and transient armature phase current measuring.───在轉子位置估測、相電流瞬時值檢測等方面提出了有效的設計方案.
Dead-time effects can be regarded as a kind of space-vector, which is determined by two factors: sector number and direction of phase current.───死區效應可被視為一種空間矢量，它由兩個因素決定：扇區數和相電流方向。
Phase current in motor stator is precisely detected by current detection circuit.───輸出相檢測電路準確的檢測到電動機定子相電流。
An intelligent PID controller was proposed for a CaC 2 furnace system with three - phase current coupled.───針對 三相 電極電流耦合的電石爐系統,設計出一種智能PID控制器.
pulsating torque component can be compensated by inject a selected harmonic component to the phase current.───轉矩脈動可以通過對定子電流加入諧波的方式完成。
英語使用場景
Nonlinear model of inductance against rotor position and phase current is constructed. Based on the model, formulae of nonlinear phase current, shearing force and radial force are calculated.
Utilizing flux linkage and phase current, the output torque is calculated, and PID control is used to decrease torque error.
The build-up of phase current to its rated value would be too slow for satisfactory operation of the motor at high speeds.
Phase current in motor stator is precisely detected by current detection circuit.
The phase current can not be maintained at its rated value and therefore the torque produced by the motor is reduced.
The induced voltage leads the phase current by the angle a and lags the applied voltage by 6.
Ways of balancing the phase current of an induction motor operating with unbalanced supply and fault diagnostics of the thyristors are discussed.
The fault phase selectors, including the phase current difference suddenly-change and the sequence current, may misoperate in some cross country faults and conversion faults.
How can the supply voltage and consequently the phase current - be increased during acceleration or deceleration?