plastic strain的意思

plastic strain中文翻譯：

塑性脅變，塑性應變

相似詞語短語

plastic surgeon───整形外科醫生

plane strain───[力]平面應變；平面變形

plastic chair───塑料椅

plastic wrap───塑料包裹膜

plastic wraps───塑料包裹膜

plastic surgeons───整形外科醫生（plasticsurgeon的名詞復數形式）

plastic surgery───[外科]整形外科

elastic stockings───彈性襪

plastic container───塑料容器

雙語使用場景

LCF life could be well expressed by plastic strain energy.───低周被勞壽命可由塑性應變能表達.

Discuss the gas flow characteristics, temperature distribution and plastic strain distribution of this catalytic converter part.───論述了該型催化轉換器的氣體流動特性、溫度分布和塑性應變分布。

Using an empirical cumulative plastic strain formula, a method for calculating the traffic load induced deformation was proposed.───交通荷載作用下軟土地基的變形問題，采用累積應變的經驗公式計算其累積沉降。

Commonly used criteria are the tool node distance, strain energy density, and critical effective plastic strain.───常用的標準工具節點距離, 應變能密度, 和關鍵的有效塑性應變.

LCF life could be well expressed by plastic strain energy.───勞壽命可由塑性應變能表達。

Plastic strain mechanism of magnesium alloy is reviewed plastic strain mechanism of ZK 60 at various temperature.───綜述了鎂合金的幾種塑性變形機制,并介紹了ZK60合金在不同溫度下的變形機制.

The vertical plastic strain is the maximum and is almost as the horizontal horizontalthe minimum.───節點塑性應變集中發生在面層中間節點附近,豎向最大,幾乎是其余兩個方向的兩倍,水平向最小.

英語使用場景

The accumulated damage model is viewed as the function of equivalent plastic strain, plastic volumetric strain and pressure.

Based on percentage of elongation the paper put forward a term of ultimate plastic strain and its expression was also given based on the law of constant volume during plastic deforming.

The result shows that the plastic strain at the heel region induced by wire bonding process, molding process and the thermal stress and strain in solder reflow are the main causes of heel crack.

In describing a non-reversible system with this model, the process is fully decided by the status parameters, intrinsic variables , loading time and cumulative plastic strain.

It is found that the relative magnitude of the total effective plastic strain for inner and outer side of ring depends on reduction ratio, initial billet size and mandrel feed speed.

The stress triaxiality and equivalent plastic strain distributions at the minimum cross-section of specimens with different notch root radius are similar for such three kinds of materials.

The theoretical result shows that the direction of plastic strain increment is determined by the direction of principal stress and stress increment.

The direction of plastic strain increment is nearly independent of the stress path. The shape of yield sur- face on...

The grid experimental method to determine principal plastic strain distribution of auto - panel stamped parts is discussed.