青年中文the cam的意思
the cam中文翻譯：
凸輪
相似詞語短語
the Ram───白羊座
the Lamb───天使與羔羊（歌曲名）
the cash───現金
the clap───掌聲
the same───同樣地；一樣
the slam───大滿貫
the Bar───律師界
雙語使用場景
When the logoff() method is called, the CAM passport will be invalidated by the IBM Cognos 8 server.───當 logoff() 方法得到調用時，IBM Cognos 8 服務器將使 CAM passport 變為無效。
Such scenarios can be handled by specifying a printmessage expression in the CAM template rules.───可以通過在CAM模板規則中指定printmessage表達式來處理這樣的場景。
CAM templates are compiled using the CAM Studio Editor before you use them with the application run-time CAMV engine.───先使用CAM Studio編輯器編譯CAM模板，然后是使用應用程序運行時CAMV引擎。
The implanted tumor was easy to grow on the CAM, and had a strong tendency of angiogenesis.───移植瘤易于生長，成瘤率較高，具有較強的血管生成誘導作用。
Take the cover off for a closer inspection of every pieces check for wear on the cam, loose items and any damaged cables.───拆下玻璃鋼保護外罩，以便能更近地檢查每一個構件是否存在磨損、松動，或其它受損構件。
At present, we mainly through artificial means on the base side of the cam piece and the cover line to the point of the scale calibration.───目前我公司主要是通過人工方法將凸輪片的基準邊與蓋板的刻度線進行對點校準。
In the case of a fl atf aced follower, such undercutting occurs when the convex radius of curvature of the cam surf ace shrinks beyond zero.───在這個案例中，這樣一種平面從動件搶發生在凸曲率半徑凸輪表面縮超越零。
All cam slides to be adjustable in the press either by an insert on the cam slide or on the driver .───在沖床中可通過在凸輪或驅動裝置上的鑲件調節凸輪滑塊。
If the wheel of the rotor is clamped with tweezers, the wheel might be deformed. Clamp the cam or magnetic part with tweezers.───如用鑷子夾住轉子頂部，轉子會變形。要夾住凹輪或帶磁的部份。
英語使用場景
The Cam always looks so peaceful, especially so on a winter's day with no punts or rowing boats in sight.
The cam component is contacted with the rolling wheel for driving the sector gear engaged with the engaging shaft gear.
The cam lever goes to C. The side levers position themselves - they're not under the knitter's control.
Both the cam and its roller are badly dented.
The cam is a crucial part of the Knitting Machine manufactures the pipes reinforced layer.
The cam follower rides against a push rod, which pushes against a rocker arm.
To change the cam, you need a front cover gasket, inlet manifold gasket and two rocker cover gaskets.
When knitting double jacquard, the cam lever is set to the jacquard or slip position.
Leave the cam assembly clapper parallel to valve body.