helix angle的意思

helix angle中文翻譯：

螺旋角; 螺旋升角; 螺旋線角; （傘齒輪的）節面角

[數]螺旋角；螺旋線角；螺旋升角；節面角（傘齒輪的）

相似詞語短語

relief angle───后角；離隙角

shelf angle───[建]座角鋼

solid angle───[天]立體角；多面角

relief angles───后角；離隙角

shelf angles───[建]座角鋼

solid angles───[天]立體角；多面角

dwell angle───n.閉合角，接點閉角；凸輪等半徑角

glide angle───下滑角

hour angle───[天]時角

雙語使用場景

Helix angle 30 2 Flutes, 3 Flutes, 4 Flutes are mainly used in the processing ordinary materials and middle - high hardness steels.───螺旋角45°至50°二刃 、 三刃 、 四刃以適用于加工中硬度鋼鐵、不銹鋼、鈦合金、鎳合金等高硬度材料的高速切削,效果更佳.

In the design of crossed-helical gears, the minimum sliding velocity is obtained when the helix Angle are equal.───在橫渡螺線齒輪設計，當節面角是相等的時，極小值滑的速度得到。

relationship between the tooth shape and the helix Angle, and the number of teeth are studied.───分析了端面齒廓形狀與螺旋角及齒數的關系。

helix angle is the same on each gear , but one gear must have a right-hand helix and the other a left-hand helix.───螺旋角度是相同的在每個之上齒輪，但是一齒輪一定有一個用右手的螺旋和另一個一個左側的螺旋。

The formulation of the helix angle of the device with tapered thread is deduced.───推導了錐螺紋的螺旋升角計算公式.

The the force location and helix angle the bend stresses of pinion and face - gear is discussed.───討論了外力作用位置沿齒長方向變化與螺旋角變化時圓柱齒輪和面齒輪彎曲應力的變化規律.

英語使用場景

Within the range of machining, if the helix angle adopts a bigger value, it may improve the meshing performance and develop the advantages of double enveloping TI worm gearing.

The helix angle is the same on each gear , but one gear must have a right-hand helix and the other a left-hand helix.

The the force location and helix angle the bend stresses of pinion and face - gear is discussed.

In this paper, the mathematical models of the orthogonal spiral-shaped curve are established and analysised, using the definition of helix angle and spiral movement.

If helix angle is equal to or slightly smaller than the angle which makes two meshing boundary lines coincide with each other, preferable meshing performance is obtained.

This paper analyzes the regularity of coil shift angle and helix angle variation and their effects on bobbin forming.

The formulation of the helix angle of the device with tapered thread is deduced.

It adopts large helix angle and special arc configuration that is suitable for processing some hard materials such as stainless steel and titanium etc.

Then, it is indicated that the gearing used presently, while its helix angle and ratio are both big enough, is in danger of interference.