青年中文tolerances的意思
tolerances中文翻譯：
v.給……定公差（tolerance的第三人稱單數）
n.界值，容差（tolerance的復數）
flatness tolerance───平面度公差
intolerant milk───不耐受牛奶
intolerant one crossword───不能容忍的一個填字游戲
gluten intolerance symptoms───面筋不耐癥癥狀
intolerable pain───難以忍受的疼痛
intolerable act date───不可容忍的行動日期
tolerate synonym thesaurus───同義詞庫
religiously tolerant───宗教上的寬容
intolerable acts 1774───不可容忍法案1774
tolerate ambiguity───模糊容忍
safe tolerances be set for unavoidable poisonous substances.───對于不可避免的有毒物質，要設定安全耐受性限度。
Measurement will be conducted with instruments suitable for the applied tolerances.───測量應使用與符合適用公差的量具測量。
Tolerances specified in the welding specification or approved WPS shall apply.───焊接規范或認可的WPS中規定的公差應予以適用。
Machining is capable of creating geometric configurations, tolerances, and surface finishes often unobtainable by any other technique.───機加工能夠達到幾何形狀，公差及表面精度，這些通常其他的技術都達不到。
Compliance with the tolerances and the requirements for the general condition lies within the responsibility of the manufacturer.───一般條件的容差和要求的符合性在制造商的責任中列出。
Since the usage of these bearings allows very loose tolerances, extreme trike frame alignment will not be a critical issue.───由于這些允許的用法非常寬松的公差，極端三輪車幀定位將不會是一個關鍵問題。
Optimal dimensional and geometric tolerances could be obtained by an appropriate optimization algorithm for the model.───求解該模型能同時得到優化的尺寸公差和形位公差。
"It is possible that the different cryptic species will have different tolerances to these chemicals, " says King.───“不同隱性物種對這些化學藥品有不同的耐藥性是可能的，”金說。
Much of this equipment has specific operational tolerances and requires forethought for the design and construction of its environment.───很多設備有其特殊的操作偏差，所以事先需要根據環境進行設計與建造。
Based on disease investigation, tolerances of major planting blueberry (Vaccinium spp. )species were compared.
Tolerances, gaps, surfaces, installation chamfers , length of bearing surface, length of stroke, frequency, speed, etc.
Tolerances for the engine lathe depend primarily on the skill of the operator.
All dimensions and tolerances apply in a free state condition.
Representation of tolerances is a basis for tolerance analysis and synthesis. Proposes a computer-aided representation method to represent geometric tolerances.
Unless otherwise specified, all geometric tolerances apply for full depth, length, and width of the feature.
Screw parameters in VGCN specified by tolerances in TN are expressed as inequation, which is inequation constraint in optimization of tolerance values.
It has tremendous tolerances for terrain and climate.
KEF analyzed the effect of component tolerances on the overall response and found that by tightening these in the most critical areas an improvement in consistency could be achieved.