青年中文青年中文

test signal的意思

test signal中文翻譯:

[自]測試信號

相似詞語短語

signal───adj.顯著的;作為信號的;n.(Signal)人名;(瑞典)西格納爾;vt.標志;用信號通知;表示;n.信號;暗號;導火線;vi.發信號

signal wire───[通信]信號線

radio signal───無線電訊號;無線電信號

home signal───進站信號(機);[鐵路]進站信號;[鐵路]進站信號機

signal processing───[通信]信號處理

alarm signal───[安全]警報信號;n.警報,警報信號

digital signal───[自][通信]數字信號

signal words───信號詞;標志詞

signal twice───發出兩次信號

雙語使用場景

Testing mechanism of the sensor is researched and the relation between test signal and tension is deduced.───研究了索張力傳感器的測試機理,導出了傳感器測力信號與索張力的關系。

The spot testing and analysis by synthesis is adopted to analyze and process the test signal.───采用現場測試與綜合分析法,對測試信號進行了分析和處理。

Online monitoring of power system test signal contains a lot of background noise, not easy to detect.───電力系統在線監測中的檢測信號含有大量的背景噪聲,不便于檢測。

With a test signal, this paper introduced three methods on threshold denoising: force threshold, default threshold and given threshold.───結合某測試信號,介紹了閾值消噪的三種方法:強制閾值、默認閾值和給定閾值。

Compared with traditional methods, difficult test signal design is avoided and isolated signal producing device isn t needed.───與傳統測試方法相比,這種方法能避免困難的信號設計過程,不需要獨立的信號發生設備。

The methods based on test signal can be used in management test task. The standard interface of layers is presented for most duplicate.───對測試任務配置時采用基于測試信號的配置方法,各層之間采用標準的接口,以提供最大限度的復用。

Cable testing instruments measure crosstalk by applying a test signal to one wire pair.───纜線測試儀器以加上測試訊號到一對線來測量串音。

In this paper, the emphases are put on the phase shifter test and the idea of the introduction of RF bit test signal to dome.───重點討論了移相器的BIT設計,以及在不占用系統資源條件下將射頻BIT測試信號引入罩內的實現方法。

And test signal should be sent no cables, transmission.───及檢測信號應可以無纜發送、傳輸。

英語使用場景

Online monitoring of power system test signal contains a lot of background noise , not easy to detect.

The methods based on test signal can be used in management test task. The standard interface of layers is presented for most duplicate.

Here, Source-Measure Unit A (SMUA) supplies the test signal to the LED and measures its electrical response while SMUB monitors the photodiode during optical measurements.

Then the frequency of the test signal is scanned at the HVDC rectifier current set point, and the oscillated active power flow in the parallel AC tie line is obtained.

Test signal through the charge amplifier, A / D data acquisition card into the computer, through professional software can show cutting power.

Using the test signal method, a detailed analysis of subsynchronous oscillation for a HVDC system is performed.

A new test signal method based approach to design power oscillation damping (POD) controller for TCSC is proposed, by which the bulky eigenvalue calculation of state matrix can be avoided.

In this paper, a software for analysing the test signal of the dynamic pressure has been developed to evaluate the waveform features, frequency structure and energy distribution.

Wish you can benefit from our online sentence dictionary and make progress day by day!