test voltage的意思

test voltage中文翻譯：

[電]測試電壓；試驗電壓

相似詞語短語

voltage limit───電壓極限

input voltage───[電]輸入電壓；工作電壓

voltage measurement───[電]電壓測量

voltage source───n.電壓電源

voltage regulation───穩壓；[電]電壓調整；[電]電壓變動率；電壓變動率，電壓調整，穩壓

doubler voltage───倍增電壓

voltage difference───[電]電壓差

voltage rating───[電]額定電壓

voltage tester───電壓檢測器

雙語使用場景

Diagram 1: Evolution of leakage current as a function of test voltage.───圖1漏電電流隨電壓變化的函數圖。

Note the exponential decay in the current using both a positive and a negative test voltage.───注意在使用正、負測試電壓時電流的指數衰減情況。

With this method, the user enters the test voltage, measurement time and the number of iterations.───使用這個方法，用戶輸入測試電壓、測量時間和重復次數。

The voltage rating of these resistors must be at least equal to the test voltage.───這些電阻器的電壓額定值必須至少等于測試電壓。

Since the voltage drop across the ammeter is negligible, essentially all the test voltage appears across R.───由于安培計上的電壓降可以忽略，所以所有的測試電壓都出現在電阻R上。

Shielding may also be applied to a conductor carrying a high level test voltage to prevent interference with nearby low level circuits.───承載高測試電壓的導體也應該采用屏蔽，以防止與鄰近的低電平電路發生干擾。

To test passive components, the tester places a test voltage across the component under test and measures the current.───在測試無源器件時，測試設備對被測試的器件施加一個測試電壓后，測量電流。

As shown in Figure 2-35, the shunt capacitance (CSHUNT) must be charged to the test voltage by the current (IS).───如圖2-35所示，并聯電容（CSHUNT）必須由測試電流（IS）充電到測試電壓。

英語使用場景

This application employs a Model 6517A Electrometer, which can supply the test voltage and measure the residual voltage.

In the paper the influences of altitude and atmosphere condition on external insulation test voltage are introduced, and the effect mechanisms are analyzed respectively.

The voltage rating of these resistors must be at least equal to the test voltage.

The resistor is first measured with test voltage V 1, giving R 1.

Note the exponential decay in the current using both a positive and a negative test voltage.

With this method, the user enters the test voltage, measurement time and the number of iterations.

Industrial frequency test voltage waveform shall be practical sine wave.

The test voltage is applied for specified period of time before the resulting current is measured.

The test voltage shall be the nominal system voltage corresponding to the ballast input voltage rating, as specified in Table 16.3.3.1.