center hole的意思

center hole中文翻譯：

[計]中心孔；頂尖孔；中心炮眼

相似詞語短語

hole───vt.鑿洞；vi.鑿洞，穿孔；（高爾夫球等）進洞；n.(Hole)人名；(瑞典、挪)霍勒；(英)霍爾；n.洞，孔；洞穴，穴；突破口

center───n.中心，中央；中鋒；中心點；vi.居中，被置于中心；adj.中央的，位在正中的；n.（Center）森特（人名）；vt.集中，使聚集在一點；定中心

drilling hole───鉆孔

through hole───透眼，透孔，通孔

castellation hole───蜂窩孔

he hole───he洞

weepers hole───泄水孔

jackson hole───杰克遜霍爾（地名）

last hole───[體]最后一穴

雙語使用場景

When machining shaft parts, always machining center hole, and then to the center of the center hole for the processing of the outer surface.───如加工軸類工件時，總是先加工中心孔，再以中心孔為基準加工外圓表面。

I first drilled the center hole in both plates in order to index them together.───首先，我鉆出中心孔在這兩個板塊在以指數他們在一起。

Some methods are put forward to assure the quality of center hole through the analysis of center hole's effect on finishing quality.───針對中心孔質量對零件加工質量的影響進行了分析，提出了幾種保證中心孔質量的方法。

Fatigue tests were carried out on the limited width specimen with center-hole.───對有限寬中心帶孔拉伸試樣進行疲勞試驗。

So the tensile fatigue tests of the limited width specimen with center-hole were performed for studying the correlation.───所以本文對有限寬板中心帶孔試件進行了拉伸疲勞試驗，用以研究這種相關性。

The results show that the center hole had obvious effect for the separation of TMG and NH3.───分析結果表明中心孔對于TMG和NH3的分隔作用明顯。

The optical media includes a disc substrate (36) having a formatted su*ce (38) and a center hole (42).───所述光學媒體包括一帶有格式化表面（38）和中心孔（42）的*基體（36）。

Aperture fan-shaped inlet design with center hole.───帶中心孔的間隙扇形分隔進口設計。

They may be sealed and filled by some working liquid or the end near the center hole are open the screw itself may also be a heat pipe.───銷可以是全部密封的內部充填一定數量工作液的熱管，也可以伸入到中心孔內端是敞口的，螺桿本身也可做成“熱管”。

英語使用場景

The fatigue behaviours of Superalloy GH901 under major combined with minor cycle have been systematically studied at room temperature using smooth specimen and sheet with center hole.

Put in the drawbar to the spindle shaft center hole.

The classification of center hole and its range of application are briefly introduced.

The nickel stamper is then cut to the appropriate diameter along with punching a center hole used to center the stamper in the moulding machine.