cause of failure的意思

cause of failure中文翻譯：

失敗的原因

相似詞語短語

Of Cause───當然

failure of───錯誤性；······的失敗

failure───n.失敗; 失敗的事/人; 沒做到; 故障; 破產; 歉收；n.失敗；故障；失敗者；破產

cause of diarrhea───腹瀉原因

the cause of───······的原因

major cause of───主要原因

cause of u───你的事業

the failure of───失敗

main cause of───主要原因

雙語使用場景

They pegged it as the cause of failure.───他們認為這就是失敗的原因。

There is but one cause of failure and that is───只有一個失敗的原因，那就是人們缺少對他們自己的信任。

cause of failure only deepens the sense of puzzlement.───失敗使迷茫的感覺更加深入。

"The risk of infection represents the primary cause of failure of alternative solutions attempted to date worldwide, " said the hospital.───院方說，“感染的風險是全球最新替代方案嘗試失敗的主要原因”。

For most projects, schedule pressure is one of the primary risks and a frequent cause of failure.───對于大多項目，時間的壓力是主要的風險，也是頻繁導致失敗的一點。

Air New Zealand spokesman said the specific cause of failure is under investigation.───新西蘭航空公司發言人說，發生故障的具體原因正在調查當中。

I've been out in the field and seen the burned-up cars and seen the reports where CAUSE OF FAILURE is recorded as "unknown. "───我去過車禍現場看到燒焦的汽車，而調查表上“車禍原因”卻填上“不詳”。

Recoverable: Failed components can restart themselves and rejoin the system, after the cause of failure has been repaired.───自我恢復：錯誤修復以后，組件能自我重啟并重新加入系統。

These remaining cuts were analyzed against specific well variables to look for trends that may indicate the cause of failure.───然后再比照具體的油井變量分析了剩下的切割，尋找可能指明失敗原因的趨勢。

英語使用場景

The major cause of failure of VRLA batteries, including grid corrosion, water loss, premature capacity loss and thermal runaway, are discussed in this .

Whatever the cause of failure, help to families has to operate on a wide front.

It is the main cause of failure in retinal reattachment surgery, recurrence of rhegmatogenous retinal detachment (RRD) and blindness after ocular trauma.

They pegged it as the cause of failure.

The major cause of failure of VRLA batteries, including grid corrosion, water loss, premature capacity loss and thermal runaway, are discussed in this paper.

Two failures happened in 2004 that were caused by over-heating of brake component related to unsuitable matching and improper operation. This paper presents the analysis on the cause of failure.

That the thread endures high alternate stress is the first cause of failure of thread joint.

The ultimate cause of failure only deepens the sense of puzzlement.

Nonminimum (NMP) phase problem is in general the cause of failure of the conventional active noise control approaches in suppressing random noises.