compressive force的意思

compressive force中文翻譯：

壓縮力

相似詞語短語

compressive───adj.壓縮的；有壓縮力的

compressive strength───[力]抗壓強度；[力]壓縮強度；耐壓強度

compressive sensing───壓縮傳感

force───n.力量；武力；軍隊；魄力；n.(Force)人名；(意)福爾切；(英、法)福斯；vt.促使，推動；強迫；強加

coulombic force───庫侖力

employ force───[法]采用武力

opponents force───反對勢力

occupying force───占領軍

striking force───擊球力量；[體]擊球發力

雙語使用場景

Results: The longitudinal continuous dynamic compressive force of SMC was 163.88n.───結果：天鵝接骨器縱向持續動態加壓力為163.88 N。

Usually the compressive force is in the form of hammer blows using a power hammer or a press, as shown in Fig. 4.1.───通常壓力都是以由如圖4.1所示的動力錘或壓力機提供的錘擊形式出現。

longer the single drill pipe, the lesser the critical compressive force of drill stem.───鉆桿的單根長度越長，鉆柱所能承受的臨界載荷越小。

The probe can be penetrated into a coating until the bottom part of the coating through the compressive force effect of the feeler arm.───探測桿在壓力作用下促使探針刺入涂層直至涂層的底部。

Press forgings. Press forgings use a slow squeezing action of a press, to transfer a great amount of compressive force to the workpiece.───壓鍛通過壓力機緩慢的擠壓動作將巨大的壓力傳遞給工件。

this workpiece is held between the centers of the lathe, If the centers exert a compressive force against the work.───如果這個工件在放在車床中心之間，中心車床對工作產生壓力。

If this workpiece is held between the centers of the lathe, the centers exert a compressive force against the work.───如果此工件是夾持在車床的兩端頂尖之間，那么頂尖就對工件施加一股壓縮力

If this work piece is held between the centers of the lathe, the centers exert a compressive force against the work.───如果工件是被夾在車床中心之間，這些中心會對工件施加壓縮力；

英語使用場景

Thus, Myosin II - dependent compressive force is necessary for normal MT bundling in the growth cone neck.

Some embodiments are configured to ascertain the amount of compressive force that is being applied to the tissue while the thickness of the tissue is being determined.

In this paper, the internal force and displacement of body of the coke drum which is suffer from temperature stress and inner compressive force are talked about.

After distraction was removed, immediate compressive force was measured. The specimen was then placed in a loading frame to simulate head weight.

These thrusts are an expression of compressive forces, which shorten the crust.

They are designed to create resistance to a compressive force.

The calculational method for plant cell compressive force was (obtained) that was convenient for theoretical analysis and numerical calculation.

Usually the compressive force is in the form of hammer blows using a power hammer or a press, as shown in Fig. 4.1.

The calculational formula for cell compressive force was (obtained) expressed by cell girth and by node coordinate and displacement of plant cell mechanical models.