contact arc的意思

contact arc中文翻譯：

接觸弧

相似詞語短語

contact───vt.使接觸，聯系；n.接觸，聯系；vi.使接觸，聯系

arc───n.弧（度）；弧光（全稱electricarc）；弧形物；天穹；vt.形成電弧；走弧線；n.(Arc)人名；(法)阿爾克；adj.圓弧的；反三角函數的

arc flash───電弧閃光

jerboa arc───跳鼠弧

fordo arc───福爾多弧

refract arc───折射弧

arc touch───弧光觸摸

arc games───弧形游戲

unharmonious arc───不協調弧

雙語使用場景

In this paper, friction field distribution between sliver and pressure bar on a homebred drawing frame is analyzed, and on this basis, the best range of contact arc is deduced.───本文以國產并條機為例，分析了并條機上須條與壓力棒上摩擦力界的分布，并進一步推導出了須條對壓力棒包圍角度的最佳范圍。

load assignment formula and the method of the double circular arc gear under the wiring error influence between the contact mark was introduced and inferred.───介紹并推導雙圓弧齒輪在安裝誤差影響下接觸跡間載荷分配的計算公式和方法。

effects of cutting area, contact arc length, the geometry of cutting face, back dip angle of PDC cutter and rock performance on force of PDC cutter breaking rock were simulated experimentally.───試驗模擬了切削面積、接觸弧長、切削面形狀、切削齒后傾角和巖石性能對PDC切削齒破巖受力的影響。

Electronic arc extinguisher - used for eliminating the contact arc on AC contact───電子滅弧器-用于消除交流接觸器的觸點電弧

英語使用場景

The results show that the plastic flow of the metal material nearby contact arc area towards free surface of workpiece becomes the burr under the coupling actions of the thermal and mechanics.

The valves for the coordination of control point contact arc tooth cylinder warm drive cutters and worm parameters are presented.

In this paper, friction field distribution between sliver and pressure bar on a homebred drawing frame is analyzed, and on this basis, the best range of contact arc is deduced.

It is necessary to calculate the cutting area, cutting volume, and contact arc of PDC bit cutters in bit' design and analysis.

Based in simulation, the results of the roll force in the contact arc, the friction force in the contact arc, and the relation of the contact friction and the roll force are gained.

The effects of cutting area, contact arc length, the geometry of cutting face, back dip angle of PDC cutter and rock performance on force of PDC cutter breaking rock were simulated experimentally.

This method can judge conveniently the position of the contact point of cam with follower and the radius of curvature and the position of the center of curvature of contact arc ...

The length of contact arc between the strip and rolls is calculated with boundary conditions.