coupling shaft的意思

coupling shaft中文翻譯：

連接軸；耦合軸

相似詞語短語

shaft───vt.欺騙；苛待；n.豎井；通風井；（電梯的）升降機井；桿，柄

coupling───v.連接（couple的ing形式）；n.[電]耦合；結合，聯結

diaphysis shaft───中間軸

coupling screw───連接[夾緊]螺釘，伸縮螺套；連接螺釘

coupling agent───[助劑]偶聯劑

mandrel shaft───心軸

coupling fluid───耦合流體

transmission shaft───n.[機]傳動軸；n.傳動軸

coupling partner───聯軸器合伙人

雙語使用場景

balance force with balance factor 0.89 is adapted to reduce bending of universal coupling shaft and load of copper slider.───軸平衡力應該采用欠平衡，平衡系數取0.89，這樣既可以降低接軸承受的彎矩，又可以降低接軸虎口銅滑塊的載荷。

voltage between the system and generator must be small enough to ensure minor current in the armature winding of generator, avoiding the impact to the coupling shaft.───發電機電壓與系統電壓之差必須足夠小，避免合閘時發電機電樞繞組電流過大，對發電機聯軸系統產生沖擊。

frequency between the system and generator must be small enough to ensure minor current in the armature winding of generator, avoiding the impact to the coupling shaft.───避免由于壓差、頻差和相角差太大，使的合閘時，發電機組電樞繞組電流過大，對發電機組聯軸系統產生沖擊。

the flat key is arranged between the connecting shaft head and the coupling shaft housing.───在連接軸頭和聯軸套之間設置有平鍵。

The cracks on universal coupling shaft resulted from large bend is analyzed by measure and theory re- search.───從現場測試與理論研究出發，分析了接軸出現裂紋的原因，認為是由較大彎矩引起的。

The lower balance force with balance factor 0. 89 is adapted to reduce bending of universal coupling shaft and load of copper slider.───提出接軸平衡力應該采用欠平衡，平衡系數取0.89，這樣既可以降低接軸承受的彎矩，又可以降低接軸虎口銅滑塊的載荷。

英語使用場景

The lower balance force with balance factor 0.89 is adapted to reduce bending of universal coupling shaft and load of copper slider.

Coupling shaft plays an important role in air cooling engine, it connects the fan with the engine and transmits torsion moment to the fan.

The cracks on universal coupling shaft resulted from large bend is analyzed by measure and theory re- search.

The phase and frequency between the system and generator must be small enough to ensure minor current in the armature winding of generator, avoiding the impact to the coupling shaft.

The voltage between the system and generator must be small enough to ensure minor current in the armature winding of generator, avoiding the impact to the coupling shaft.