conversion loss的意思

conversion loss中文翻譯：

[電]變頻損耗

[經管]變換損耗

相似詞語短語

conversion───n.轉換；變換；[金融]兌換；改變信仰

loss───n.(Loss)人名；(匈)洛什；(法、德、意)洛斯；n.減少；虧損；失敗；遺失

metric conversion───公制換算

conversion option───兌換選擇權；轉換期權

dekaliter conversion───dekaliter轉換

meter conversion───儀表轉換

conversion chart───換算表；[計]轉換圖

conversion factor───[數]換算因數；[數][核]轉換因子；[統計]變換因數；轉換因數; 換算因數; 變換因數; 轉換因子

currency conversion───貨幣兌換；外匯匯兌

雙語使用場景

The conversion loss and noise temperature of mixers is determined by changing the IF noise temperature so as to change the noise temperature of the receiver system.───混頻器的變頻損耗和噪聲溫度的測量可以用改變中頻部分的噪聲溫度使接收機的系統噪聲溫度變化來加以確定。

waveguide designator and corresponding multiplier factor overlays help in deciphering the typical conversion loss values.───波導設置和相應的乘數因子疊加有助于改善轉換損耗值。這些結果是一個較典型的案例。

for measuring the conversion loss and no- ise temperature of all kinds of the single or balanced mixers, subharmo…───了八毫米波段半衡混頻器的變頻損耗和噪聲溫度的測量結果。

dielectric resonators image rejection image recovery conversion loss ratio.───標簽介質諧振器鏡像抑制鏡像回收變頻損耗。

Effect of Ports SWR of Mixer on Conversion Loss───端口駐波比對混頻器變頻損耗影響

英語使用場景

Thecalculation formulas of conversion loss and input and output impedance areobtained.

Finally, the measurement results of the conversion loss and noise temperature of a balanced mixer in 8 mm waveband are also presented.

An example for measuring the conversion loss and noise temperature of mixers in millimeter wave band by using the noise measurement method is discussed in this paper.

A low conversion loss and high isolation X-band single balanced mixer is developed in this paper, using commercially available Schottky barrier diode HSMS-2822.

The mainly finished task of this paper is designing and simulating an V band downconverter with low conversion loss , which realized by use of passive 4th harmonic mixing.

It can be used for measuring the conversion loss and no- ise temperature of all kinds of the single or balanced mixers, subharmo...

The conversion loss and noise temperature of mixers is determined by changing the IF noise temperature so as to change the noise temperature of the receiver system.