cutting temperature的意思

cutting temperature中文翻譯：

切削溫度

相似詞語短語

temperature───n.溫度；體溫；氣溫；發燒

cutting───adj.尖酸刻薄的；嚴寒的，刺骨的；鋒利的；v.切割；鑿成；剪短；把……切碎；劃破（cut的現在分詞）；n.剪報；插枝，插條；狹窄通道，路塹；切割，切斷；割下的東西；n.（Cutting）（美、澳、印）卡廷（人名）

cutting line───切割線；截線

cutting down───研磨修整；磨掉

cutting shapes───切割形狀

cutting board───n.切肉板

critical temperature───[物][電子]臨界溫度；n.臨界溫度

temperature outside───室外溫度

temperature rise───[電]溫升；溫度上升；溫度上升，溫升，升溫

雙語使用場景

measurement system of milling transient cutting temperature is developed.───切削溫度的改變。

Change in the cutting temperature.───切削溫度的變化。

Then cutting temperature in high speed milling of titanium alloy TA15 was measured by an embedded semi-artificial thermocouple.───然后采用了夾絲半人工熱電偶法對鈦合金TA15的銑削溫度進行了測量。

Cutting heat, cutting temperature and their effects are the important research contents of high speed cutting technology.───切削熱與切削溫度的產生和影響是高速切削技術研究的重要內容。

The highest cutting temperature point is always at face near the cutting edge.───切削溫度的最高點總是位于前刀面上距離刀刃不遠的地方。

Through testing the device installed in flames shot after the fire after cutting temperature are obviously different.───通過測試火焰槍在安裝該裝置后完成火焰切割后溫度有明顯不同。

Therefore, cutting temperature and volume of the two static data in shaping the course of grain it is particularly important.───因此，切削溫度和靜電量這兩個數據在藥柱整形過程中顯得尤為重要。

The maximum cutting temperature increases with the increase in cutting speed.───最高切削溫度隨著切削速度的增大而增高。

英語使用場景

The variation of cutting force and cutting temperature Al - Si alloy cutting with diamond cutter are investigated.

The cutting temperature rise with the increase of the cutting speed, so high-speed cutting conditions should be made sure not to bum the cutting tool.

The mechanism of cutting force, cutting temperature and tool wear in the machining of quenched steel and nickel based high temperature alloy with ceramic tools are analyzed in the paper.

It is capable of displaying temperature flexuous curve, calibrating thermocouple, establishing the cutting temperature exponential formulation and predicating the state of cutting.

Tempered martensite was gradually generated as the cutting temperature increased, which is the main cause of the decrease in the hardness.