curing temperature的意思

curing temperature中文翻譯：

[化工]固化溫度；加硫

相似詞語短語

curing───[化學]固化；（肉、魚等的）[食品]腌制，調制；醫治；食物加工法；cure變形

temperature───n.溫度；體溫；氣溫；發燒

curing marijuana───治療大麻

critical temperature───[物][電子]臨界溫度；n.臨界溫度

curing ballots───養護選票

post curing───后固化；后熟化

curing time───固化期，熟化期，熟化時間；硬化時間，[化工]固化時間

ballot curing───選票補救

temperature outside───室外溫度

雙語使用場景

Take the average temperature in the curing time as curing temperature.───養護溫度取各濕噴樁養護期的平均氣溫。

This may be done in a reciprocating screw machine where one charge at a time is brought to curing temperature.───這可能是在做往復螺桿機，其中一名主管在一個時間是帶來的固化溫度。

curing temperature and alkali contents of cement on expansion of mortar bars are investigated.───研究了養護溫度和水泥堿含量（質量分數，下同）與硅質集料砂漿試樣膨脹的關系。

The influence of concentration of the finishing agent, cross-linking agent and curing temperature on the finishing result was investigated.───探討了整理劑濃度、交聯劑濃度、焙烘溫度等對整理效果的影響，并在此基礎上優化工藝參數。

The influence of treating methods of the cotton fabric, curing temperature, addition of salt and bath ratio upon dyeing are also discussed.───文章還討論了棉織物處理方式、焙烘溫度、鹽及染色浴比對染色的影響。

the strength and durability of RPC gradually increase with the curing temperature increased.───隨著養護溫度的提高，RPC強度和耐久性能逐漸提高。

Effects of graphite content, curing time and curing temperature on the properties of the composite were studied with orthogonal test.───采用正交試驗方法研究了石墨含量、固化時間以及固化溫度對復合材料的影響。

Of course, curing temperature is not possible.───當然固化溫度并不是越高越好。

The influence of curing reaction heat on curing temperature field of cubic rubber block and tire was investigated.───探討長方體膠塊和輪胎硫化反應熱對硫化溫度場的影響。

英語使用場景

It's curing temperature high and difficult to molding.

For traditional thermal curing powder coatings, there has a big limit of high curing temperature.

Of course, curing temperature is not possible.

Prolongation of the lay-by time of HAA/T-12 and raising the curing temperature will achieve the same results in shortening the pot-life of the binder curing reaction.

Effect of curing temperature, curing time, resistance to media, kind and volume of the sand-laden fluid, and particle size of proppant on fibre compound sand control system were discussed.

The hardness of highlights oil and different light oil have different best curing temperature.

A system of epoxy resin , anhydride and accelerator was selected which efficiently promoting the curing speed and decreasing curing temperature.

When curing temperature was preferred to be 260 and the percentage of solidification agent was 3 %.

Through analyzing each factor such as concentration of citric acid and chitin, curing temperature as well as curing time, the optimum condition is defined for the anti-crease finish.