degree of hardness的意思

degree of hardness中文翻譯：

硬度；偏心度

相似詞語短語

hardness───n.[物]硬度；堅硬；困難；冷酷

a degree of───一定程度上的

degree───n.程度，等級；度；學位；階層

durometer hardness───[力]計示硬度

hardness tester───硬度試驗機；硬度測定儀

degree of confidence───可信度，[統計]置信度；信賴度

degree of freedom───[物]自由度

adverbs of degree───程度副詞

the degree of───……的度（音階或度數）；……的學位；……的程度

雙語使用場景

The maximum degree of hardness obtainable in steel by direct hardening is determined largely by the carbon content.───直接淬火后的剛所能獲得的最大硬度在很大程度上時由含碳量決定的。

Die head and blades USES the alloy material, high degree of hardness ultra wear-resisting, surpasses the overseas similar product.───模頭及刀片采用合金材料，高硬度超耐磨，優于國外同類產品。

sartorius fitting's degree of hardness can reach above 60, and some even can reach above 65.───縫紉機配件硬度都可以達到60度以上，最高可以達到65度以上。

The hydrogenation can be controlled to produce any degree of hardness desired in the product .───氫在食品工業中對于所謂的氫化過程也很有用。

Even if erects again immediately, feminine bioelectricity also because penis degree of hardness will reduce, will reduce.───即使馬上再勃起，女性生物電也會因為陰莖硬度降低，降低。

Tempering: tempering is a process of reducing the degree of hardness and strength and increasing the toughness.───回火：回火是減少硬度和強度并提高韌性的一種工藝。

Soft gum series: TPR: Has (degree of hardness to be allowed soft to achieve 0).───軟膠系列：具有柔軟（硬度可以做到0度）。

Hard chrome plating is a high degree of hardness and wear resistance and chemical stability.───軟鉻鍍層有很矮的軟度及矮度的耐磨性和化學安定性。

英語使用場景

The findings as follows: For 5BB grafts, its adult plant grew exuberantly, its germinating ratio and fruit ratio was relatively high, fruit quality fine, degree of hardness high, storable.

The hydrogenation can be controlled to produce any degree of hardness desired in the product.

SO4 grafts, its adult plant had medium growth ability, germinating rate and fruit branch rate higher, fruit degree of hardness value highest, storable, fruit quality fine, the flavor is good.

The knife board shovel cape may act according to the soil degree of hardness the difference, adjusts the knife board to be buried the angle.

The highest degree of hardness reaches 456HV at higher flame intensity. The degree of hardness is related to the scanning rate of flame but not flame intensity.

Uses in each kind of medium degree of hardness solid material , in cement industry, limestone in broken bits , paste , chamotte, and so on mix material .

The deep formation has a high degree of hardness and abrasivity; the bit type selection is difficult and the ROP is low especially under the high density mud.

These sartorius fitting's degree of hardness can reach above 60, and some can reach above 65.

If a low degree of hardness is satisfactory, through-hardening is probably the most desirable heat treatment process to be used because of its inexpensiveness .