青年中文青年中文

cylinder wall的意思

cylinder wall中文翻譯:

缸壁

相似詞語短語

cylinder───n.圓筒;汽缸;[數]柱面;圓柱狀物

oxygen cylinder───儲氧筒,氧氣瓶;氧氣瓶;儲氧筒

circumscribing cylinder───外切圓柱

cylinder head───[機]氣缸蓋

armorack cylinder───軍械架筒體

pneumatic cylinder───氣缸,氣壓缸

actuating cylinder───[機]作動筒;[動力]主動油缸;制動氣缸;作動筒; 主動筒; 動力氣缸; 主動油缸

master cylinder───[機]主缸;制動缸;控制缸;主缸; 主油缸; 控制缸

dynamometric cylinder───測力計氣缸

雙語使用場景

It passes over the top of the ring, and gets behind it to force it outward against the cylinder wall.───氣體流過密封環頂端并進入其后面,施加向外的壓力到缸筒壁上。

The main section of a piston is known as the skirts. It forms a bearing area in contact with the cylinder wall.───活塞的主要部分叫活塞裙部。其與氣缸壁接觸形成了支承面。

cylinder swirl is mainly formed by the strong air flow near the cylinder wall.───缸內渦流主要由氣缸周邊處的強氣流產生;

The heat damage led to cracking through the cylinder wall. Salvage was not possible.───熱損傷導致內筒壁穿透性裂紋而無法彌補。

In the two-cycle engine, the piston ACTS as a valve, clearing valve ports in the cylinder wall as it nears BDC.───在二行程發動機中,活塞起到閥門的作用,當活塞接近下止點時,使氣缸壁上的進排氣口打開。

The repeated measurement data to cylinder wall at the same location , basically described the same change of degree of uniformity.───對圓筒內壁同一位置圓周的多次測量數據基本描述了該圓周的一致均勻度變化。

For most engines, cast iron has been found to be a satisfactory cylinder-wall material.───對于大部分發動機來說,鑄鐵是氣缸壁的良好材料。

The oil -control rings scrape off excessive oil from the cylinder wall and return it to the oil pan .───油環的作用是刮去氣缸壁上多余的機油,使之流回油底殼。

英語使用場景

Helical port also produces swirl by airflow interaction of valve gap and cylinder wall, so swirl number depends on helical line direction of relevant cylinder center.

Compressing the rings gives them an initial tension; they press tightly against the cylinder wall.

The heat damage led to cracking through the cylinder wall. Salvage was not possible.

A hole in the lower part of the cylinder wall lets in gas and air.

The cylinder wall profile has direct influence on discharge volume, pressure variety and vane's motion.

As the piston nears BDC , it passes the intake and exhaust ports in the cylinder wall. Burned gases, still under some pressure, begin to stream out through the exhaust port.

It equipped with piston rings to provide a good seal between the cylinder wall and piston.

As the piston moves in the cylinder bore, the piston rings press against the cylinder wall, providing a seal for combustion gases and keeping lubricating oil from being burned.

The main section of a piston is known as the skirts. It forms a bearing area in contact with the cylinder wall.