deformation rate的意思

deformation rate中文翻譯：

變形率；應變率

相似詞語短語

deformation───n.變形

plastic deformation───塑性變形，柔性變形；[力]塑性變形，塑性應變

ductile deformation───延性變形；柔性變形

deformation gradient───[力]變形梯度

deformation retraction───形變收縮

deformation definition───變形定義

elastic deformation───彈性變形；[力]彈性形變

deformation geology───變形地質學

rate───n.(Rate)人名；(法、塞)拉特；n.比率，率；速度；價格；等級；vi.責罵；被評價；vt.認為；估價；責罵

雙語使用場景

It concluded that deformation rate showed specific effect on the four textural parameters involved, but deformation degree had none.───結果表明，壓縮程度對考察的四個質構參數有顯著影響，壓縮速率無顯著影響。

of eutectic decreases slightly with the increase of deformation rate.───共晶熔化開始溫度隨形變率的增大略有下降。

If the cold deformation rate is higher than 70 %, the recrystallized grain size distribution agrees with lognormal distribution.───在冷形變量大于或等于70 %時，其再結晶晶粒尺寸分布符合對數正態分布。

Vertical suspended sintering furnace with a production of small, sintering deformation rate of over 95% of the benefits, but complex.───筆直懸掛燒結爐具有燒結變形小，不敗品率達95%以上的弊端，但擺設駁雜。

Deformation rate influence the temperature rise of forging, a reasonable choice could influence the forging of forming to a certain extent.───變形速率影響鍛件的溫升，其合理選擇對鍛件成形有一定影響。

The interface stability and the interfacial bonding strength is getting better with the reduction of the interface deformation rate.───界面變形率越小，界面穩定性越好，界面結合強度越高。

With the humidity further diffusion, the deformation of tunnel increases but the deformation rate decreases, and eventually converges.───隨著濕度的進一步擴散，隧洞的變形總量增加，但變形速率逐漸降低，并最終得以收斂；

The influence of rainfall and excavation on slope displacement is proven immediately by increasing slope deformation rate.───同時監測結果表明，降雨和開挖使邊坡位移速率顯著增大。

It concluded that deformation rate had specific effect on the four textural parameters involved, but little effect on deformation degree.───結果表明，壓縮程度對考察的四個質地參數有顯著影響，壓縮速率無顯著影響。

英語使用場景

If the cold deformation rate is higher than 70 %, the recrystallized grain size distribution agrees with lognormal distribution.

The isoplethes of vertical deformation rate or their tangents are almost perpendicular to fault line.

Flow stress of different temperatures and deformation rate on AZ31B magnesium alloy sheets of different preparation method was studied by tensile test machine and metalloscope.

The results show that cold-roll texture mainly consists of copper-type texture, R-type texture and some S-type texture, when the general deformation rate is 96%.

With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.