deformation temperature的意思

deformation temperature中文翻譯：

變形溫度

相似詞語短語

deformation───n.變形

temperature───n.溫度；體溫；氣溫；發燒

plastic deformation───塑性變形，柔性變形；[力]塑性變形，塑性應變

ductile deformation───延性變形；柔性變形

deformation gradient───[力]變形梯度

deformation retraction───形變收縮

deformation definition───變形定義

elastic deformation───彈性變形；[力]彈性形變

deformation geology───變形地質學

雙語使用場景

Dynamic recovery and recrystallization of the composite generate with the increasing of deformation temperature.───隨變形溫度升高，復合材料發生動態回復再結晶。

Effect of strain rates on peak flow stress is relate to deformation temperature.───應變速率對峰值應力的影響與變形溫度有關。

Thermal deformation temperature and liner expansion coefficient of the composite were decreased.───該復合材料的熱變形溫度有所降低，但線膨脹系數減小。

The resin toughness, the casting of the thermal deformation temperature is a good comprehensive performance winding resin.───該樹脂韌性好，是一種綜合性能良好的纏繞用樹脂。

Deformation temperature and the deformation velocity will affect critical deformation, and thereby affect the dynamic recrystallization.───變形溫度，變形速度等因素都會影響臨界變形量，從而影響動態再結晶。

The results showed that the flow stress and deformed microstructure were greatly affected by strain rate and deformation temperature.───結果表明：應變速率和變形溫度對合金的流變應力與變形組織有顯著影響。

Within a certain range, grain size becomes small as deformation temperature declines and strain rate rises.───在一定范圍內，降低變形溫度提高變形速度可使動態再結晶晶粒尺寸減小，隨變形程度增大，晶粒變得細小。

The results show that the flow stress decreases with the deformation temperature increasing and strain rate decreasing.───結果表明：合金的流變應力隨著變形溫度的升高和應變速率的降低而降低；

decreasing deformation temperature, the kinetics of phase transformation was accelerated.───隨著形變溫度的降低，過冷度增加，相變動力學過程加快。

英語使用場景

With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.

Coarse crystalline LC4 Aluminium Alloy presents certain superplasticity at lower deformation temperature and higher strain rate because it can create effective recrystallize refinement.

The results show that the static softening rate increases with the increase of deformation temperature and holding time, the size of grain is bigger too.

The results show that coarse crystalline LC4 Aluminium Alloy can present certain superplasticity at proper deformation temperature and velocity.

The resin produced by the flame-retardant products with high strength and mechanical properties, thermal deformation temperature, curing speed, and good soak.

The results showed that the grain boundary cohesion become weaker and intergranular fracture became dominant with the increasement of superplastic deformation temperature.