deformation zone的意思

deformation zone中文翻譯：

變形區

相似詞語短語

deformation───n.變形

plastic deformation───塑性變形，柔性變形；[力]塑性變形，塑性應變

ductile deformation───延性變形；柔性變形

deformation gradient───[力]變形梯度

deformation retraction───形變收縮

deformation definition───變形定義

elastic deformation───彈性變形；[力]彈性形變

deformation geology───變形地質學

Zone───n.(Zone)人名；(塞)佐內；vi.分成區；n.地帶；地區；聯防；vt.使分成地帶；環繞

雙語使用場景

From the plastic flow theory, the three-dimensional deformations and stresses of the deformation zone are formulated.───根據塑性力學流動理論，分析推導了變形區三維變形和應力的數學模型。

Segmentstion is characteristic in the Ziyun deformation zone.───紫云變形帶上的分段運動特點十分顯著。

calculation method of the flattening in sheet rolling deformation zone, using influence function, was derived.───采用影響函數法推導了薄板軋制時變形區內軋輥彈性壓扁的計算式。

The results show that, in the shoulder deformation zone, the fine grain is similar to that of the center of friction stir zone.───結果表明：攪拌摩擦中心區晶粒尺寸與軸肩變形區相似，晶粒比較細小；

With this method, the deformation zone can be very accurately determined.───用這種方法，變形區可以非常準確地確定。

The temperature field of the bar in and out the deformation zone during continuous rolling is simulate by finite element method.───采用有限元法分析了棒材連續熱軋中變形區及出變形區時軋件橫斷面溫度場。

The temperature field of the bar in and out the deformation zone during rolling is simulated by FEM .───采用有限元方法分析了棒材連續熱軋中變形區及出變形區時軋件橫斷面溫度場。

Meanwhile, the phenomenon of two peaks of temperature on crack tip in the deformation zone is discovered.───同時，發現變形區內裂紋尖端發生溫度成雙峰變化規律。

Initially identified the distribution and formation mechanism of strong deformation zone and fractured zone in front of the face.───初步確定了回采工作面前方煤體強烈變形帶、破碎帶的分布范圍和形成機制。

英語使用場景

A calculation method of the flattening in sheet rolling deformation zone, using influence function, was derived.

While taking soil deformation into account, the internal dissipation rate in the deformation zone caused by the cohesion variation is half of that occurs on the logarithmic spiral slip surface.

Consequently, it was found that a certain deformation zone length depending on the temperature distribution is necessary to satisfy the geometrical similarity law in cross section.

The Mannesmann barrel-shaped rolls can be designed arid processed easily, but it makes the non-linear deformation zone in skew-rolling and leads to the inhomogeneous wall thickness.

Linear deformation zone of generating wall can be obtained by means of non-linear cone angle plug combined with the barrel-shaped rolls, so the wall accuracy can be increased greatly.

According to the feature of the deformation zone in ring gear gag precision blanking , the effect of hydrostatics stress on metal plastic is analyzed in the theory.

On the basis of experiment and change of metal flow line, metallographic structure and micro-hardness in deformation zone, this paper researched process, characteristic and mechanism of fine-blanking.