青年中文drawing force的意思
drawing force中文翻譯：
[機]拉伸力，[機]拉拔力；拉力
drawing───v.繪畫；吸引（draw的ing形式）；拖曳；n.圖畫；牽引；素描術
force───n.力量；武力；軍隊；魄力；n.(Force)人名；(意)福爾切；(英、法)福斯；vt.促使，推動；強迫；強加
scale drawing───[測]比例圖；縮小圖；按原物比例畫的畫
headdress drawing───頭飾圖
still drawing───仍在繪制
eyeball drawing───眼球牽引
drawing in───（白晝）漸短；（汽車或火車）到站；穿經；收回（銀行券等）
flames drawing───火焰繪圖
draft drawing───草圖
reduction affects drawing temperature little and its increasing lowers drawing force.───變形程度對拉伸溫度影響小，變形程度的增大使拉伸力下降。
So the solution can be used to calculation of drawing force during draw-out by idle rolls.───因而，該解析解可在工程上計算圓管輥拔拔制力時推廣應用。
The thinning drawing force is calculated through deforming work method and slip-line method irrespectively, and the results are compared in this paper.───本文用變形功法和滑移線法分別求解變薄拉深力，并將兩種方法的計算結果進行了比較。
When the roller passes through the roving, a certain twist level can be untwisted, and thereby the drawing force is reduced.───當粗紗須條在輥輪經過時能退去一定的捻度，使牽伸力降低。
Under the same air flow, the side - lay's drawing force in the single - sheet feeding mode is stronger than in the stream feeding mode.───在同樣氣體流量前提下，間歇輸紙的側規拉紙力比連續輸紙要大。
It is shown that steel strength can be decreased, plasticity can be increased and drawing force can be reduced by electroplastic drawing.───試驗結果表明，電塑性加工技術，可有效地降低鋼絲生產中的拉拔力，降低鋼絲的強度，提高塑性。
This model have considered the effect of friction to well head drawing force, especially curved portion must take friction into account.───該模型在前人研究的基礎上考慮了摩阻力對井口提拉載荷的影響。
Hydraulic is used to supply the deep drawing force of punch, the blank holder force and the cavity hydraulic pressure.───利用液壓提供凸模拉深力、壓邊力以及凹模容腔壓力；
In a certain range. drawing force is reducing along with the increasing of drawing speed, which was reached by test.───通過試驗得出拉拔力在一定范圍內是隨著拉拔速度的提高而降低的。
The said experiments show that with the roll-die drawing process the drawing force can be considerably reduced and surface quality of the shape steel tube improved.
The drawing force, rational wall - thickness reduction and the characteristics of cold-draw process and equipment are analyzed.
The analyze of drawing force model is well meeting to the experimental result. Foundation is laid for optimal design of die structure and technological design of tube plug drawing mill.