drawing speed的意思

drawing speed中文翻譯：

[機]拉拔速度

相似詞語短語

drawing───v.繪畫；吸引（draw的ing形式）；拖曳；n.圖畫；牽引；素描術

speed───v.快速運動；加速；促進；（使）繁榮；超速駕駛；（非正式）用興奮劑成癮；n.（Speed）斯皮德（人名）；n.速度，速率；進度；迅速；繁榮；感光度；排擋；（非正式）安非他明

scale drawing───[測]比例圖；縮小圖；按原物比例畫的畫

headdress drawing───頭飾圖

still drawing───仍在繪制

eyeball drawing───眼球牽引

current speed───流速；當前速度

telegraphic speed───電報速度

Speed in───速度輸入

雙語使用場景

geometric parameter change of optical fiber at different drawing speed is analyzed.───分析了在不同拉絲速度下，光纖幾何參數的變化。

The drawing speed has little influence on the strength variable coefficient.───拉伸速度的變化對強度變異系數的影響不大。

affection of drawing speed to the internal quality of billet was discussed.───研究了拉速對方坯內部質量的影響。

The system has met the requirements of slab casting, improved continuous drawing speed and reduced the cost.───該系統滿足了板坯鑄鋼要求，提高了連檢率，降低了生產成本。

Comprehensive consideration, low drawing speed is good to the improvement of internal quality.───綜合考慮，低拉速有益于普碳鋼方坯內部質量的提高。

Firstly, It estimated the number of corners using the drawing speed and the density of sample points, and then divided strokes in corners.───利用筆觸的繪制速度和型值點密度來估計筆觸中的角點數量，并對角點進行識別；

The affection of drawing speed to the internal quality of billet was discussed.───本文研究了拉速對方坯內部質量的影響。

The drawing speed increases with time non-linearly.───拉拔速度隨時間呈非線性增加；

In a certain range. drawing force is reducing along with the increasing of drawing speed, which was reached by test.───通過試驗得出拉拔力在一定范圍內是隨著拉拔速度的提高而降低的。

英語使用場景

For the force-feed lubrication drawing process, the effects of the reduction and drawing speed on the property and microstructure have been discussed.

For the force-feed lubrication drawing process the effect of the reduction and drawing speed on the property and microstructure has been discussed.

The results show that the drawing speed is related to the feed speed, the size of the blank pipe, the size of the tapered pipe and the hot-to-cold source distance.

Effects of different configurations of the submerged nozzles, the pool height and flow rate (drawing speed) on the fluctuation of the flow level have been empathetically analyzed. The experimental...

In the end the relationship of steel grades, mould length, drawing speed and sectional dimensions of the billet with mould taper and solidification and contraction coefficient has been discussed.

PDLLA/HA composite fibers were produced by melt spinning, and the choices of the process parameters such as temperature, revolving speed and drawing speed etc were discussed.

Crispy Plotter is a function graph plotter for mathematical functions, featuring high drawing speed and an intuitive interface that is fun to use.