electrochemical etching的意思

electrochemical etching中文翻譯：

電化學腐蝕

相似詞語短語

etching───adj.蝕刻的；v.蝕刻；刻畫（etch的ing形式）；n.蝕刻術；蝕刻版畫

electro-etching───電腐蝕（electroetch的現在分詞）

etching gel───蝕刻膠

etching solution───蝕刻劑；蝕刻溶液

etching primer───腐蝕性涂料；[化] 防護涂料; 磷化底漆; 洗滌底漆; 反應性底漆

electrochemical cell───[電]電化電池

callot etching───卡洛特腐蝕

plowman etching───犁鏵蝕刻

electrolytically etching───電解腐蝕

雙語使用場景

the third chapter Porous silicon was prepared by pulsed and dc electrochemical etching methods under the equivalent etching condition.───第三章研究了用脈沖電化學腐蝕制備均勻發光多孔硅。

Based on electrochemical etching principles, the paper fabricated the micrometer scale wire electrodes used in WEMM.───本文基于電化學腐蝕原理，制備微細電化學線切割加工中使用的微米尺度線電極。

PSMs were prepared by the pulsed electrochemical etching method and the experimental conditions were optimized.───用電化學脈沖腐蝕法制備多孔硅微腔，優化了實驗參數。

Firstly, PSMs were prepared by the pulsed electrochemical etching method and the experimental conditions were optimized.───用電化學脈沖腐蝕法制備多孔硅微腔，優化了實驗參數。

New developments on electrochemical etching processes at the Atomic Energy organization of Iran.───伊朗原子能機構電化學蝕刻技術的新發展…[中國核科技信息與經濟研究院]。

The fabrication of alloy microelectrodes by electrochemical-etching method is presented.───采用電化學刻蝕法制備了合金微電極。

Double-cell electrochemical etching is used to prepare PS based on p+ type silicon.───以p+型硅片為基底，通過雙槽電化學腐蝕法制備多孔硅。

Preparation of Uniformly Luminescence Porous Silicon by Pulsed Electrochemical Etching Method───電化學脈沖腐蝕制備均勻發光多孔硅

英語使用場景

With the orthogonal experiment, porous silicon(PS) was fabricated by galvanostatic electrochemical etching method.

Porous silicon (PS) was prepared by the electrochemical etching technique with self-made cell. The orthogonal experimental method is adopted to design anodization parameters.

P-type Silicon crystal plates have been adopted in the paper. Then the electrochemical etching experiments are done in three electrodes electrobath .

The electrochemical etching technique of PN junction etch-stop in alkaline solution KOH is one of foundational methods of fabricating three-dimension silicon microstructures.

Tungsten STM tips made by electrochemical etching are always covered with a layer of oxide film, which greatly affects the quality of STM images.

Firstly, PSMs were prepared by the pulsed electrochemical etching method and the experimental conditions were optimized.

We propose to machine cylindrical micro-pins using the electrochemical etching method to control their shape and dimension.