end winding的意思

end winding中文翻譯：

端繞組

相似詞語短語

winding───adj.蜿蜒曲折的；v.蜿蜒而行；纏繞；卷繞；被彎曲；環繞（核心）；給（鐘表等）上發條；轉動（鑰匙、把手）；（使）（錄像帶、錄音帶等）倒退（或前進）；（用絞車等）吊起（某物）；（使）氣急；輕拍后背使（嬰兒）打嗝；嗅出（人或動物的）氣味；（詩、文）吹（號角）（wind的現在分詞）；n.卷繞；線圈；蜿蜒曲折的路徑；n.(Winding)（美）溫丁（人名）

winding river───（美）風河系統公司；溫德河（美國懷俄明州河流）

armature winding───[電]電樞繞組

end for end───對調兩端位置地；兩端的位置顛倒過來；反過來，顛倒; 調個頭

winding stairs───螺旋式樓梯

winding trip───繞組跳閘

winding trail───蜿蜒的小徑

winding up───清算；停業清理；清理; 結業

winding road───連續彎路；彎曲路

雙語使用場景

causes and preventing measures for the stator end winding incident are summarized in the paper.───文章總結了產生定子端部線棒事故的原因和防止措施。

special structure of submersible motor, the leakage reactance in end winding of stator and rotor are analyzed respectively.───的理論基礎，然后針對潛油電機的這種特殊結構，分別分析計算其定轉子端部漏抗。

Two degree of freedom principal resonance of generator end winding is studied when the clamping plates are loose.───松動時大型汽輪發電機定子端部單根繞組的兩自由度主共振問題進行了研究。

In this paper, the modal of large turbogenerator stator end winding is studied using impulse technique.───本文用錘擊法對某大型汽輪發電機定子端部繞組進行了模態研究。

Double Frequency Measurement on Stator End Winding of Large Turbo- Generator and Its Model Analysis───大型汽輪發電機定子繞組端部二倍頻測量及模態分析

Calculation of Stator End Winding Leakage Inductance of Synchronous Generators with AC and DC Stator Connections───交直流混合供電發電機定子繞組端部漏電感的計算

The Calculation and Measurement of End-Winding Leakage Inductance of Multiphase Electric Machines───多相交流電機端部漏感系數的計算與測量

Investigation on Standard for Dynamic Characteristics of Generator Stator End Winding───發電機定子端部繞組動態特性標準探討

Fundamental Resonance and Bifurcation of Large Generator End Winding When Its Clamping Plates Are Loose───壓板松動時大型發電機端部繞組的主共振與分岔

英語使用場景

To the special structure of submersible motor, the leakage reactance in end winding of stator and rotor are analyzed respectively.

Two degree of freedom principal resonance of generator end winding is studied when the clampingare loose.

In this paper, the insulating fastness system in end winding for Three - gorges generator.

The vibrational characteristics of stator end winding and its fastener of a large turbo - generator are studied.

In this paper, the modal of large turbogenerator stator end winding is studied using impulse technique.

Characteristic analysis is used in internal discharges, slot discharges and end winding discharges.