extrusion ratio的意思
extrusion ratio中文翻譯:
[機]擠壓比
extrusion online───擠出聯機
joggled extrusion───點動擠壓
extrusion companies───擠壓公司
ratio───n.比率,比例
variation ratio───異眾比率;變異比率;變速比,變速范圍
extrusion thermoforming───擠壓熱成型
extrusion gis───擠壓地理信息系統
extrusion reflex───擠壓反射
click ratio───點擊率
So fine aluminum conductor wire can be produced by the proposed process and under proper extrusion ratio.───合理的擠壓比,可直接生產性能良好的鋁合金導電線材。
With the increasing of extrusion ratio, both tensile strength and extensibility are improved.───隨著擠壓比的增加,抗拉強度和伸長率提高。
Increasing of extrusion ratio was beneficial to the improvement of mechanical properties of composites.───提高擠壓比,有利于復合材料性能的提高。
As observed before, since the wheel velocity does not affect the defect occurrence, the limiting extrusion ratio is not affected by it.───正如之前觀察得知,由于轉輪速度并不影響缺陷發生,所以限制擠壓比也不會受到影響。
the relationship curves between the extrusion speeds and extrusion force for different extrusion ratio are obtained.───分析了擠壓力隨擠壓速度及擠壓比的變化規律。
So fine aluminum conductor wire can be produced by the proposed process and under proper extrusion ratio.───采用合理的擠壓比,可直接生產性能良好的鋁合金導電線材。
The corrosion rate and degree is decreased with increased extrusion ratio and decreased chips size.───隨著擠壓比的增大,屑粒尺寸的減小,腐蝕程度減輕,腐蝕速率呈遞減趨勢。
Fig. 9 illustrates the limitations of the extrusion ratio with respect to the other four process parameters.───表9說明了在其他四個加工參數下的擠壓比的限制性。
The hot extrusion of magnesium alloy sheet under high extrusion ratio is investigated.───探討高擠制比之鎂合金板材熱間擠制加工。
The author proposes a local extrusion ratio method to determine the location of extrusion die hole.
The stress and temperature effect increase with increasing extrusion ratio and ram speed.
中文翻譯推薦
- extrusion pump
- extrusion rate
- extrusion product
- extrusion rheometry
- extrusion rheometer
- extrusion rheometre
- extrusion speed
- extrusion quality
- extrusion spinning
- extrusion screw
- extrusion stress
- extrusion stabilityl
- extrusion stem
- extrusion swelling
- extrusion stroke
- extrusion swell
- extrusion temperature
- extrusion technology
- extrusion test
- extrusion time
- extrusion velocity