built-up edge的意思

built-up edge中文翻譯：

[機]切屑瘤

相似詞語短語

built up───[機] 組合; 同“build”；確立；增進（健康）；集結（部隊）

built-up───adj.組合的，拼合的；建筑物多的；以增添組件而加高

built up area───建筑面積，已建設區；建成區

built up to───加強；建造多達...；加大

edge up to───側身走近

built───adj.有……體格的；身段優美的；……建成的；v.建造，建立；逐步增強；把……嵌入（墻壁、物體等）（build的過去式和過去分詞）

edge───n.(Edge)人名；(英)埃奇；vi.緩緩移動；側著移動；n.邊緣；優勢；刀刃；鋒利；vt.使銳利；將…開刃；給…加上邊

clipper built───剪裁器制造

built on───以…作基礎

雙語使用場景

An integrated dynamometer and quick-stop device is developed to investigate into some problems about built-up edge and scaling.───本文研制了一種測力—落刀裝置，對積屑瘤和鱗剌的某些問題進行了試驗研究。

By electronic microscope analysis, it is found that there is a certain amount of second dispersed phase in the martensite matrix which is the metallurgical factor of forming built-up edge.───通過電鏡分析，發現在馬氏體基體上有一定數量的彌散的第二相存在是引起積屑瘤產生的冶金因素。

Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.───帶切屑瘤的連續切屑：這種切屑顯示了粘合或“焊接”在刀具面上材料局部高度變形區的存在。

Furthermore, an effective cutting lubricant can reduce the surface roughness because it reduces the built-up edge.───此外，一個有效的潤滑劑，可以減少切削表面粗糙度，因為它減少了重建邊。

Note that soft steels can be difficult to machine, with built-up edge formation and poor surface finish.───注意，軟碳鋼很難機，采納裝配式邊形成和可憐的外貌光潔度。

The new coating has a low friction co-efficient to minimize the risk of built-up edge and improve chip evacuation.───這種新型涂層摩擦系數小，減少了內置邊緣的風險，利于排屑。

A built-up edge results in a rough surface.───結果在建筑物多邊緣粗糙的表面。

Continuous chip with built-up edge───連續切屑附積屑刃口

英語使用場景

By electronic microscope analysis, it is found that there is a certain amount of second dispersed phase in the martensite matrix which is the metallurgical factor of forming built-up edge.

The new process improves toughness and chipping resistance and thus reduces friction and built-up edge.

A built-up edge that has been created on the cutting edge of the tooling.

Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.

An integrated dynamometer and quick-stop device is developed to investigate into some problems about built-up edge and scaling.

Note that soft steels can be difficult to machine, with built-up edge formation and poor surface finish.