clamp force的意思

clamp force中文翻譯：

夾緊力

合模力

相似詞語短語

clamp science───夾具科學

sliding clamp───滑動壓板

earth clamp───接地夾子[端子]；[電]接地夾子；地線夾

cable clamp───[電]電纜夾；索卡; 線夾

damper clamp───減震器夾

anastomosis clamp───n.吻合夾

clamp back───夾緊

clamp meter───鉗型電流表

clamp off───沖砂

雙語使用場景

We all know that if you don't have enough clamp force for the projected area of the parts, flash will result.───我們都知道對于相應的產品投影面，如果沒有足夠的鎖模力的話，可能會有飛邊產生。

Clamp force parameter setting is very important in plastic injection molding.───注塑生產中，鎖模力參數設計十分重要。

obtain the best gate location addition, the position of air bubble and the clamp force were forecasted.───預測可能存在的氣泡位置及鎖模力的大小，確定最佳澆口位置。

When the close time of the nozzles was set at the end of packing, the injection pressure, clamp force and parts quality were all better.───同時當澆口均設置為保壓結束時關閉，成型中的注射壓力、鎖模力以及制件質量較為理想。

This method of evaluating the slip rate was introduced in the clamp force control used on CVI and tested on rotary drum lest bench.───將該滑移率評估方法在無級變速器夾緊力的防滑控制中進行應用，并在轉鼓試驗臺上進行實車試驗。

So, the angular distortion decreases under the action of the gravity of specimens and the clamp force of jigs.───在重力和夾具夾持作用下，焊接試板的角變形減小。

Because the theoretical calculating method of clamp force is very complex, a simplified experiential calculating method is provided.───鑒于鎖模力的理論計算較為復雜，本文提出了一種簡化的計算方法。

Calculation of the Mould Clamp Force of Injection Moulding Machine───注塑機鎖模力的計算

英語使用場景

We all know that if you don't have enough clamp force for the projected area of the parts, flash will result.

The system consists of optimal module of clamp force, control module of clamp force, executive module of clamp force, etc.

So, the angular distortion decreases under the action of the gravity of specimens and the clamp force of jigs.