cooling temperature的意思

cooling temperature中文翻譯：

冷卻溫度

相似詞語短語

cooling───adj.涼快的，涼爽的；冷卻的；n.(Cooling)（英、美）庫林（人名）；n.冷卻，降溫

temperature───n.溫度；體溫；氣溫；發燒

heart cooling───心臟降溫

cooling medium───[制冷]冷卻介質；冷媒

cooling towel───冷卻毛巾

cooling agent───[制冷]冷卻劑

cooling curve───[晶體]冷卻曲線；步冷曲線

cooling systems───冷卻系統

critical temperature───[物][電子]臨界溫度；n.臨界溫度

雙語使用場景

influence of rolling temperature, final cooling temperature, cooling speed and micro-alloying on microstructure and properties were investigated.───分析了軋制溫度、終冷溫度、冷卻速度以及微合金化對鋼筋組織、性能的影響。

ratio of acicular ferrite may increase by raising cooling speed and decreasing final cooling temperature.───提高冷卻速度和降低終冷溫度可以增加針狀鐵素體的比例。

The main reasons of CSP work roll flaking in Lianyuan Steel are the uneven slab temperature, uneven roll cooling temperature and the rolling accident.───漣鋼CSP工作輥發生剝落的主要原因是板坯溫度不均、軋輥冷卻溫度不均和軋制事故。

Spheroidal annealing structure is satisfactory and hardness increases with the decrease of final cooling temperature.───隨著終冷溫度的降低，軸承鋼球化退火后球化組織均勻，硬度增大。

The quenching quality of heavy rail was directly influenced by temperature of heat treatment and air cooling temperature.───重軌熱處理溫度及氣冷溫度對重軌淬火質量的提高有直接的影響。

The heating and cooling temperature and time were important in the rotational micro-wave heating molding.───微波加熱的加熱溫度和加熱時間在微波加熱工藝也具有著重要的作用。

It takes time for the cooling temperature to stabilize.───冷卻水溫度安定時間長。

the target temperature of a fast-cooling area is set according to the cooling temperature required by the cooling load;───根據冷卻負載所需冷卻溫度，相應地設置快冷區域內目標溫度；

The results showed the higher the cooling temperature of water bath, the higher the initial crystallinity would be;───結果表明：水浴冷卻溫度越高則薄膜的初始結晶度越高；

英語使用場景

In the simulation, thermal and mechanical properties, concrete construction, pipe cooling, temperature variation of environment. crown filling and water impoundment orders are considered.

To achieve the same final cooling temperature at constant cool-down different laminar cooling patterns play important roles in the cool-down rate along plate gauge and temperature distribution.

The lower finish cooling temperature, the shorter interlamellar spacing in pearlite colonies and the higher tensile strength and ductility are.

The heating and cooling temperature and time were important in the rotational micro - wave heating molding.

To achieve the same final cooling temperature at constant cool-down rate, different laminar cooling patterns play important roles in the cool-down rate along plate gauge and temperature distribution.

The influences on washing soda were discussed, including cooling temperature distribution of cooling kettle, the medium and stir speed of mixer, the retention period of material in cooling material.