bushings的意思

bushings中文翻譯：

n.[電]套管；軸襯；支架避震組（bushing的復數形式）

相似詞語短語

oiled bronze bushings───油青銅襯套

雙語使用場景

Upper and lower bushings are standard for smooth valve operation.───上部和下部襯套符合流暢平穩輕松操作閥門的標準要求。

Un-housed VCA shipped as Coil Assembly and Field Assembly, without shaft and alignment bushings.───線圈，現場組裝，船運不配自調整軸承和絕緣套管。

Exposed to elevated temperatures with some finishes intact or bushings installed.───暴露到惡劣的溫度條件下，接觸到涂層或裝有襯套。

Put a little on each side of wheels and cams at the bushings and let soak down into the axles as well.───投入一點在輪子和凸輪的每邊在軸襯并且讓浸泡下來入軌。

Both bushings' mechanical properties can meet the work requirements, but equal thickness wall bushing is better than conventional.───兩種襯套的力學性能均能滿足螺桿馬達的工作要求，但等壁厚襯套要優于常規襯套。

The company mainly produces seal ring, nozzles, bushings , drilling teeth, solder films, ball valves, valve seats and other products.───公司主要生產密封環、噴嘴、軸套、鉆齒、釬片、閥球、閥座等產品。

Each rod pivots about a separate vertical axis through the bushings and is spring biased toward one side of the base plate.───約一個單獨通過套管垂直軸桿的每個支點，正朝著一個底板側偏的彈簧。

Do not drop or kick the master rotary bushings into position. Always use insert tools and hoist them into pastor.───不要投放或踢縮小方瓦，應該用公用工具提著放入。微型攝像頭。

By the way of fixing and supporting bushing with the cylindrical fixture, the grinding of bushings in lathe can be realized.───采用套筒定位和夾持瓷套，可實現在車床上對瓷套進行磨削。

英語使用場景

If Master Bushings, Insert Bowls and slips coordinate properly, the uniform load can distribute over the most gripped place, the pipe would not be torn and worn.

Our modular control is ideal for lower-cavity applications like direct-feed bushings and smaller hot runner systems.

Therefore the bushings, bearings, cam apertognathia, needle roller bearings and other parts must be intact.

Worm wheel and gear transmission with long - life bushings, so that the machine is durable.

Through the analysis on the result of calculation a thorough discussion has been carried out on the effect of air film on the back of bush for bushings with elastic or rigid support.

Minor wear and tear in the journal, simply press out the old bushings with new bushings, and revised from time-axis in general, it can get back to the gap with the extent permitted.

Graphite impregnated "IEM" type bushings. No grease fitting required. All lifters require one bushing at top of rod clearance hole (at pocket).

Level3: Tolerance matching of freewheel bushings. Factory only.

The grooves for double Oring seals are machined in the stem sheath of protective plastic for redundant stem leakage protection in conjunction with both the upper and lower bushings.