bath temperature的意思

bath temperature中文翻譯：

鍍浴的溫度；電解質溫度；熔體溫度

相似詞語短語

temperature───n.溫度；體溫；氣溫；發燒

bath───n.沐浴；浴室；浴盆；vt.洗澡；vi.洗澡

critical temperature───[物][電子]臨界溫度；n.臨界溫度

whirlpool bath───漩渦浴

take bath───洗澡

temperature outside───室外溫度

temperature rise───[電]溫升；溫度上升；溫度上升，溫升，升溫

constant temperature───[熱]恒溫；定溫；等溫；等溫，恒溫

fluctuating temperature───波動溫度；脈動溫度；脈動溫度，波動溫度

雙語使用場景

The ultrafiltration rate of pure water with the coagulation bath temperature increased.───隨著凝固浴溫度的升高，所成的膜的透水速率上升。

Coagulant bath temperature had a strong influence on PU, PES composite flat membrane.───凝固浴溫度對填充聚合物平板膜有很大影響。

Try to put vanities, bath temperature water, such as water turbidity found to water until the clear-up.───試放面盆、浴缸的冷熱水，如發現水質混濁，須放水，直到水清為止。

The grain size of Pd is increased with increasing current density or bath temperature, but is slightly affected by coating thickness.───鈀鍍層的晶粒尺寸隨電流密度的增加或溫度的升高而變大，但受膜厚的影響不大。

The preheat oven is used to bring the pump up to the metal bath temperature.───進口工業網的預熱烤箱是用來使泵送金屬浴溫度。

But only to the radiation to the local area heating, without giving the whole a warm bath, bath temperature equilibrium.───但是，只有到當地，輻射加熱，而不給予整個熱水澡，浴室的溫度平衡。

Improve the bath temperature, and check the temperature control system.───提高浴溫，并檢查溫控系統。

These crosslinkers are stable in water at normal bath temperature but become reactive at curing temperatures.───這些交聯劑于正常槽液溫度下在水中很穩定，但在固化溫度下就變得活潑起來。

A Fuzzy-Expert Control of the Aluminum Electrolysis Bath Temperature and Ratio───鋁電解質溫度和分子比的模糊專家控制

英語使用場景

The effects of current density, bath temperature and coating thickness on the solderability and wetting balance of Pd coating electroplated on phosphor-bronze were studied.

The retention rates of Albumin bovine decreases when coagulation bath temperature increases, and first decreases, then increases when pre-evaporation time prolongs.

The water flux increases along with the prolonging of pre-evaporation and the increasing of coagulation bath temperature.

The influence of ammonium molybdate, cobalt sulphate, ammonium bifluoride, acidity of blackening bath, blackening bath temperature and time on film quality were studied.

Porosity increases along with the increasing of coagulation bath temperature, and doesn't have relation to pre-evaporation.

The bath temperature, liquidus and anode effect were controlled by adjusting the AlF3 additions, aluminum tapping magnitude, cell voltage set-point and the alumina feeding interval.

Microcomputer control, touch switches, seven files of arbitrary power conditioning, meet the needs of different bath temperature, faster and more comfortable.