adhesion force的意思

adhesion force中文翻譯：

[力]附著力；粘附力

相似詞語短語

adhesion───n.粘附；黏附（力）；支持；固定；

fibrous adhesion───纖維性粘連

adhesion promoter───助粘劑，附著力促進劑

adhesion belt───黏合帶；粘合帶

adhesion test───附著試驗；粘連試驗；附著力試驗

homotypic adhesion───[醫]同質性粘附

adhesion molecules───黏附分子；粘附分子

adhesion molecule───[醫]黏著分子，黏附分子

force───n.力量；武力；軍隊；魄力；n.(Force)人名；(意)福爾切；(英、法)福斯；vt.促使，推動；強迫；強加

雙語使用場景

adhesion force between the spheres and the chip surface was affected by the ligand surface concentration.───球與基片表面的結合力受到配基面密度的影響，說明發生結合的是多對而非單對蛋白質分子。

surpassed the properties including water-resistance, weather durability and adhesion force.───水性、耐候性、附著力等性能均超過相應國家標準。

METHODS Orthogonal design was used with the adhesion force as the index in the experiment.───方法采用正交設計法，以黏著力為指標，對巴布劑基質配比進行實驗研究。

Results The adhesion force and cohesive strength could be affected by the contents of sodium polyacrylate, PVA, Gelatin.───結果配方中各因素對粘著力、剝離強度的作用大小依次為聚丙烯酸鈉、聚乙烯醇、明膠。

With the increase of the sintering temperature, the adhesion force of Ni electrodes enhances, and the square resistance decreases.───結果表明，隨著燒結溫度的增加，鎳電極附著力逐漸增大，方阻逐漸下降；

Lab experiments shows that the lubricant have important influence on adhesion force, lubrication and surface tension.───室內實驗表明，潤滑劑對粘滯系數、潤滑性以及表面張力有重要的影響。

Specific Properties: Non-toxic, passed "SGS" safety, and Enviromental. Good Flow properties Adhesion force. Easy operating.───特性：無毒、合乎環保要求，流動性好，硬性，快固化，粘合力強，易操作。

The crude emulsion has high adhesion force, so it can carry more mechnical impurity, and block the oil bed.───原油乳化液具有較高的粘附力，攜帶的機械雜質給油層造成堵塞。

Single Micropipette Aspiration Technique for Measuring the Shearing Adhesion Force of Cells───單微吸管測量細胞切向粘附力方法的研究

英語使用場景

And the bogie is one of the major components of a vehicle, it transfer every kind of forces, and produce tractive force using adhesion force between wheel and rail.

TOP BEST-665 has high surface adhesion force on vacuum bag and a variety of tools. It is cost-effective and shows excellent sealing performance.

TOP BEST-661 has high surface adhesion force on vacuum bag and a variety of tools. In the curing cycle it has excellent seal, and very easy to remove from the cold or heating surface after the curing.

It was found that the adhesion force between the spheres and the chip surface was affected by the ligand surface concentration.

The modification the resin matrix can enhance the adhesion force to temperature alter and heat proof.

Results The adhesion force and cohesive strength could be affected by the contents of sodium polyacrylate, PVA, Gelatin.

The lean setae with large end had anisotropy adhesion property, and during the forward sliding course the shear adhesion force was 3.5 times greater than that during the backward slipping course.

The causes of polluting molds surface were analysed in this paper. The main adhesion force between the rubber particles of the molds surface and the substrate is van der waals force.