bending angle的意思

bending angle中文翻譯：

[機]撓曲角，[材]彎曲角

相似詞語短語

bending───n.彎曲，彎曲度；v.彎曲（bend的現在分詞）

flatwise bending───平面彎曲

bending over───俯身；折轉

flexural bending───塑性彎曲

anticlastic bending───抗塑性彎曲

bending moment───[力]彎矩；[力]彎曲力矩；[力]撓矩；彎（曲）矩，撓矩

angle───n.角，角度；視角；立場；角鐵；（古）魚鉤；v.斜移；從……角度提供信息；釣魚；謀取

healing angle───愈合角

face angle───齒面角；[數]面角

雙語使用場景

bending Angle increases with an increase of the energy density.───增加能量密度，板料的彎曲角度顯著增大。

The reasons that the bending angle decrease with the number of irradiation are analyzed by using the built model.───用建立的模型分析了多次掃描過程中隨掃描次數增加彎曲增量逐漸減小的原因。

This paper introduces how to obtain and assimilate the GPS bending angle.───文中介紹了如何獲得及同化GPS折射角資料的原理。

do not use, we recommend that the lights turn back the body in situ, to better maintain a permanent compact The bending angle.───不使用時，建議將燈身折回原位，以便更長久保持緊致的折彎角度。

Rotating shoulders, spine bending angle remains unchanged, and the head behind the move to the ball position.───在旋轉肩膀時，一直保持脊椎彎曲角度不變，且頭部移動到球位的后面。

At the same press bending angle, the cross section distortion of the tubes decreases by increasing the distance between the die fulcrums.───在相同的壓彎彎曲角度下，增大凹模支點的間距可以減小管坯截面的畸變。

Relationship between the bending angle and geometry of sheets and technological parameters is discussed.───論證了板料的幾何參數和工藝參數與變形的相互關系。

For the same amount of bending angle, the springback increase linearly with the increase of bending radius.───對于一定的彎曲角度，零件端部回彈量隨彎曲半徑的增加而線性增加；

The bending angle of a joint is related to its inner air pressure.───關節彎曲角度與關節內的氣體壓強有關；

英語使用場景

Researched friction loss and ultimate strength of external prestressing tendon considering deviator curvature radius and bending angle of prestressing tendon.

The bent-tube is a kind of special part with rectangular section, which has a right bending angle, and the traditional bending process is unsuitable.

The results show that: the springback angle of bent tube increases with the bending angle, the gap between mandrel and tube, and the hardening coefficient, but decreases with the hardenability value.

The atmospheric refractivity profiles below the height of the GPS receiver are obtained with this inversion technique, as well as the bending angle of rays.

A simple focusing technology is proposed. The influences of laser power, scan times, scan rate, distance of focusing on bending angle are analyzed respectively.

Bending angle about material augments along with laser power and laser light spot diameter augment, but bending angle about material minishes along with laser scan rate and material hardness augment.