bridge method的意思

bridge method中文翻譯：

橋接法

相似詞語短語

bridge───vt.架橋；渡過；n.橋；橋牌；橋接器；船橋；n.(Bridge)人名；(英)布里奇

method───n.方法；條理；類函數

biffin bridge───雙鰭橋

bridge over───在…上架橋; 應付，克服; 跨接；在…上架橋；渡過；暫時幫助

bridge rectifier───[電子]橋式整流；[電子]橋式整流器

eyebar bridge───眼球橋

gasometric method───氣體容量法，氣體定量分析法

teaching method───教學方法；教學方式

setter method───塞特法

雙語使用場景

On the basis of the above models, conflicts are tackled by extension transformations and transforming bridge method.───在模型建立的基礎上，運用可拓變換和轉換橋等可拓學的思想與方法，對沖突問題進行處理。

Three methods on measuring high resistance improved electric bridge method, voltage method, and comparative method are introduced in the article.───三種測量高值電阻的方法：改進電橋法、電壓法、比較法，并用這三種方法對同一高值電阻進行了測量。

The detection circuit uses alternating current capacitance bridge method and the principle is based on the correlated demodulation.───檢測電路為基于相關檢測原理的交流電容電橋的方法。

This paper briefly introduced the way which check the position of the cable short circuit spots by current bridge method.───簡介用電橋法檢測電纜短路點的位置。

Alternating frequency range influence on the conductivity measurements of electrolyte solutions using alternating current bridge method───交流頻率對交流電橋法測定電解質溶液電導率的影響

The analysis to the electric bridge method in the measurement of the voltampere characteristic of diode───對電橋法測二極管的伏安特性的分析

Methods of measurement of value of dielectric loss tangent for power cables (high voltage alternating current bridge method)───電力電纜介質損失角正切值測量方法（交流高壓電橋法）

Simple remembering monosaccharide molecular structure by using the building- bridge method───利用搭橋法簡化記憶單糖分子結構

it is also introduced details in the paper for the simulation bridge method composition, working principle and measures of raising accuracy;───詳細介紹了仿真電橋的構成、工作原理及提高測試精度的各種措施等；

英語使用場景

The Curie temperature and saturation magnetization of manganese-zinc ferrite were measured by using the electric bridge method, induced method and vibrating sample magnetometer (VCM).

The detection circuit uses alternating current capacitance bridge method and the principle is based on the correlated demodulation.

The principle of location of cable breakdown point by the HV bridge method is presented. The main factors affecting the location accuracy are analyzed in detail and tests are made using this method.

The measuring of self-inductance coefficient by means of direct current bridge method has reduced the difficult and improved the precision of measuring.