friction loss的意思

friction loss中文翻譯：

[力]摩擦損失

相似詞語短語

friction head loss───摩擦水頭損失

friction───n.摩擦，[力]摩擦力

loss───n.(Loss)人名；(匈)洛什；(法、德、意)洛斯；n.減少；虧損；失敗；遺失

friction factor───[力]摩擦因子；摩擦率；摩擦率，摩擦因數

palp friction───觸須摩擦

friction factors───阻力系數；[力]摩擦因子；摩擦率

fluid friction───[流]流體摩擦；鈴摩擦

coulomb friction───[力]庫侖摩擦

limiting friction───極限摩擦

雙語使用場景

the flood wave was not deformed in motion, there was no internal friction loss, which is called kinematic wave.───在運動中不變形，則沒有內摩阻損失，即所謂運動波。

It is shown that the friction loss is about 60 percent of the total loss.───研究結果表明：磨擦損失功率約占整機機械損失功率的60％。

Friction loss factors of hydraulically smooth pipes have been calculated by using several different turbulent models.───應用幾種不同的湍流模型，模擬計算水力光滑管的沿程阻力系數。

Considering the friction of the rotor surface, the wind friction loss of the rotor was calculated.───考慮轉子表面的摩擦，計算出電機轉子風摩擦損耗。

The first is its own internal pump friction losses, pump fluid and the second is between the entrance wall of the friction loss.───第一是泵自身內部的摩擦損失，第二是流體與泵入口管壁之間的摩擦損失。

Impeller on the requirements of internal and external surface smooth, to reduce the flow of friction loss.───葉輪上的內外表面要求光滑，以減少水流的摩擦損失。

Worm gear and worm drive, meshing gear meshing of the relative speed between sliding friction loss is big, so, the low efficiency.───蝸輪蝸桿嚙合傳動時，嚙合輪齒間的相對滑動速度大，故摩擦損耗大、效率低。

The generator loss is composed of iron loss , bearing friction loss , bushing friction loss and windage loss .───發電機損失由鐵阻、軸承摩擦損失、套管摩擦損失和風阻組成。

英語使用場景

The pump performance would be affected by the two clearances in such a way that the clearance alters both volumetric leakage power loss and mechanical power loss (dick friction loss of impeller).

Total Head—Sum of discharge head, suction lift, and friction loss.

This paper determines standard uncertainty for measurement of windage and friction loss of three-phase induction motor through fitting line of least square method.

The results show that the friction loss increases with the increase of the particle diameter, density, volumetrical concentration of the solid phase and the velocity of liquid phase.

Researched friction loss and ultimate strength of external prestressing tendon considering deviator curvature radius and bending angle of prestressing tendon.

In terms of the numerical computations, the effects of particle diameter, density, volumetrical concentration of solid phase, and the velocity of liquid phase on the friction loss are studied.

The generator loss is composed of iron loss, bearing friction loss, bushing friction loss and windage loss.

The pump shaft power is generally water, power, friction loss of power and leakage power of these three parts combined.

The results show that the friction loss coefficient is the key factor affecting the efficiency of pump. The density ratio has a moderate effect on the property of jet pump.