aluminum foam的意思

aluminum foam中文翻譯：

泡沫鋁

相似詞語短語

foam───vi.起泡沫；吐白沫；起著泡沫流動；n.泡沫；水沫；滅火泡沫；vt.使起泡沫；使成泡沫狀物

aluminum───n.鋁

foamed aluminum───泡沫鋁

brushed aluminum───拉絲鋁

aluminum cans───鋁質罐；鋁包殼

boose aluminum───boose鋁

foam eraser───泡沫橡皮擦

aluminum case───鋁合金外殼；鋁制箱子

aluminum hydroxide───[化] 氫氧化鋁; [醫] 氫氧化鋁；[無化]氫氧化鋁

雙語使用場景

pore morphology and cell wall microstructure of aluminum foam during powder metallurgical foaming was studied.───研究了粉末冶金法制備泡沫鋁時泡沫孔結構及胞壁微觀組織變化的規律。

One of the potential USES of foam aluminum is used as aluminum foam sandwich.───泡沫鋁的潛在用途之一是作為泡沫鋁夾芯板的芯材使用。

Bubble size plays a significant role to the aluminum foam performance.───氣泡直徑是影響泡沫鋁性能的非常重要的因素。

Due to its low thermal conductivity , PCM is more effective if coupled with Aluminum fins and Aluminum foam .───如果要增加鋁散熱片和鋁泡沫膠時，由于PCM的低導熱性，使它的性能更加有效。

The thermal conductivity coefficient of closed-cell pure aluminum foam was measured as a function of porosity and cell size.───采用隔熱測試儀研究了閉孔泡沫純鋁的孔隙率和孔徑對其導熱性能（導熱系數）的影響。

The quasi-static and dynamic compression mechanical properties of sandwich panel with aluminum foam core have been studied in this paper.───本文對泡沫鋁芯體夾層板材的準靜態和動態力學性能進行了試驗研究。

The sound insulation property of aluminum foam(Al-foam) with composite structure was studied using a self-made equipment and sound detector.───采用自制的試驗裝置對泡沫鋁與實體鋁復合結構的隔聲性能作了研究。

Compared with the non-filled structures, aluminum foam-filled structures need less mass and volume to absorb the specified energy.───在吸收的能量一定時，泡沫鋁填充結構能夠減少吸能結構所需要的體積與質量。

The electrical conductivity of the aluminum foam was connected with the parent materials'.───而且泡沫鋁的電導率隨著基體材料電導率的增強而增強。

英語使用場景

There are three main interior structure defects in the preparation of aluminum foam with melt foaming process such as free-bubble-layer at the bottom, partial free-bubble-zone and heat crack.

The sound insulation property of aluminum foam(Al-foam) with composite structure was studied using a self-made equipment and sound detector.

It's been quite a few years since Cymat Technologies Ltd. built the world's first commercial stabilized aluminum foam (SAF) casting line—1998 to be exact.

Aiming at structure and property control, a closed cell aluminum foam with the same composition but different cell structures was prepared by air-foaming process.

Fly ash particles act as viscosity increaser wall in the aluminum foam.

The calculated results obtained with the static and dynamic models are capable of accurate predicting the bubble size under varied conditions of processing the closed cell aluminum foam.

Cell-size has a significant effect not only on the crushing stress and plastic modulus of aluminum foam, but also on the strain-rate sensitivity of material of this kind.