initial temperature的意思

initial temperature中文翻譯：

[熱]初始溫度

相似詞語短語

initial───n.詞首大寫字母；原始細胞；adj.最初的；字首的；vt.用姓名的首字母簽名

temperature───n.溫度；體溫；氣溫；發燒

critical temperature───[物][電子]臨界溫度；n.臨界溫度

Initial Rings───初始環

initial beauty───最初的美麗

temperature outside───室外溫度

full initial───全名首字母

temperature rise───[電]溫升；溫度上升；溫度上升，溫升，升溫

shared initial───共享首字母

雙語使用場景

So I'll start at some initial temperature, T1.───那么我從某個初始溫度T1開始。

initial temperature of solid heat carrier has great influence on the gas composition.───熱載體初始溫度對熱解氣組成影響顯著。

Initial temperature of catalyst bed is wholly too high.───提高起始反應溫度使催化劑床層溫度整體過高導致飛溫。

controlling cooling rate can be realized by controlling the initial temperature, bellows-strip spacing and jet rate of the cooling gas.───控制冷卻速度可以通過控制帶鋼初始溫度、帶鋼與風箱間距和冷卻氣體噴出速度等參數來實現。

The results indicated that the absorbent cotton and bamboo had a lower initial temperature than polypropylene when pyrolyzed .───與纖維素類的脫脂棉和竹子相比，聚丙烯的分解反應起始溫度明顯較高。

Thus, the errors of the estimated initial temperature of the system could cause a big error for the modeling results.───初始溫度估計的偏差會使模擬結果產生很大的變化；

The entanglement achieved by fields heavily depends on their initial temperature and the detuning.───這個通過熱場獲得的糾纏深深的依賴于初始熱場的溫度和失諧。

One way is increasing the combustion initial temperature, and the other is reducing the gas turbine inlet air temperature.───提高燃氣輪機的出力和熱效率有兩種方法，一種方法是提高燃燒初溫，另一種方法是降低燃機進氣溫度。

Meanwhile, the methods of getting the initial temperature and the fitness function are discussed.───對初始溫度的確定方法和獲得適應度函數的方法進行了探討；

英語使用場景

Then the authors analyse the effect of initial temperature and cooling rate on thermal stress and the low temperature cracking performance of different asphalt cement.

Through inspection of MSDB process, it can be found that initial temperature of solder droplet is the main influential factors for reliable bump.

The results indicated that the absorbent cotton and bamboo had a lower initial temperature than polypropylene when pyrolyzed .

The pulverized coal-air flow ignition limit is mainly influenced by such parameters as initial temperature, ignition source temperature, coal rank and the fineness of the pulverized coal.

There exists a lowest temperature, reliable MSDB bump can be achieved only when initial temperature of solder droplet is above this temperature.

Influence of the initial temperature fields and mold hardness on the shrinkage defect of ductile iron casting by EPC process was mainly investigated in this paper.