inlet temperature的意思

inlet temperature中文翻譯：

入口溫度；進氣溫度；進入溫度

相似詞語短語

inlet───v.引進;嵌入;插入;；n.入口，進口；插入物；水灣

temperature───n.溫度；體溫；氣溫；發燒

inlet elbow───進口彎頭

inlet grove───入口槽

water inlet───進水口; 進水管；[建]進水口，吸水口

critical temperature───[物][電子]臨界溫度；n.臨界溫度

inlet definition───入口定義

inlet wildwood───入口原木

temperature outside───室外溫度

雙語使用場景

inlet temperature and internal temperature of exhaust catalyst for two stroke moped are tested under different vehicle driving speed.───不同車速行駛工況下對二行程輕便摩托車用尾氣催化劑的入口及中心溫度進行了測量與分析。

Inlet temperature distortion is one of the key factors effecting engine stability.───發動機進口溫度畸變是影響發動機穩定性的關鍵因素之一。

For rolling dryer, the higher filling power value corresponds to downstream quickly drying way, higher inlet temperature and moisture content.───對于轉筒式烘絲機，采用順流烘絲方式，較高的來料溫度和水分，較大的熱風流速，可獲得較高的烘絲填充力。

Whereas, the heat transfer of turbulence liquid film flow is not sensitive to liquid film inlet temperature.───湍流時，熱量傳遞對液膜進口溫度的反應不如層流敏感。

Lowest viscosity can be obtained when inlet temperature and mixing temperature are in certain range.───當進口溫度和混合溫度穩定在一定范圍時，產品黏度最低。

Viscosity of pseudo-boehmite remains unchanged when inlet temperature is in certain range.───進口溫度在一定范圍時，產品黏度基本保持不變；

The effects of nozzle structure, operating pressure, solid content and inlet temperature on alumina properties are discussed.───討論了噴嘴結構、固含量、操作壓力及進口溫度對微球氧化鋁性能的影響。

Changing the kill fluid capacity and inlet temperature can adjust the wellbore temperature effectively.───調整泥漿排量和泥漿入口溫度可以作為調節井筒溫度的有效途徑。

Then, based on the simulation results the influence of inlet temperature and flow rate of cooling water on the performa. . .───根據仿真結果分析了冷卻水進口溫度和流量的變化對廢熱驅動型吸收式機組的性能影響。

英語使用場景

As for the dehumidifying conditions, the condensing rate for the humid air increases with Reynolds number but decreases as the inlet temperature of cold water increases.

The wall temperature increases with a rise of inlet temperature, but changes of the wall temperature distributions of the flame tube are not obvious.

In this method, the dispersion and overall change of the cavities'frequency can be controlled by changing water flux and inlet temperature of cooling water.

It can be seen that if the engine air inlet temperature is higher and the ambient pressure is lower than the standard conditions , the power output of the effects will be lower.

In this article, the main influencing factors on condensation heat transfer include air flow rate, coolant flow rate, coolant inlet temperature and mixed gas velocity.