青年中文motor current的意思
motor current中文翻譯：
電動機電流
電機電流
motor───vi.乘汽車；n.發動機，馬達；汽車；adj.汽車的；機動的；vt.以汽車載運
current───adj.現在的；流通的，通用的；最近的；草寫的；n.（水，氣，電）流；趨勢；涌流；n.（Current）（英）柯倫特（人名）
motor error───電機故障
rocket motor───[航]火箭發動機
motor bike───n.摩托車
electric motor───[電]電動機；電動機; 電滾子
actuator motor───驅動電動機，執行電動機；伺服電動機
gear motor───齒輪電動機，齒輪馬達
cogging motor───齒槽電機
This paper describes the control of the motor current, velocity and position.───本文介紹了電機的電流、速度和位置控制。
The compensation method can effectively improve motor current waveform, the inverter's output performance can be greatly enhanced.───該補償方法能有效改善電機導流波形，提高了逆變器的輸出性能。
The varying characteristics of motor current in vari-speed cutting are discussed in this paper.───本文就變速切削過程中電機電流的變化特征進行了較為系統的研究。
By means of parameter testing of motor current and moment, the design and choices of experiment components are accomplished.───完成了實驗系統元件的設計和計算選型，通過對電機的電流、轉矩等性能參數的測試。
This product paves the way for a smaller, lighter, easier to produce, high noise rejection, low cost solution to motor current sensing.───此產品鋪平了道路，為更小，更輕，更容易生產，高噪聲抑制，低成本解決方案，以電機電流感應。
Fuzzy PID motor current controller is designed to make sure the good tracking character of its output current.───設計了模糊PID電機電流控制器使得電機的輸出電流有很好的跟蹤特性；
motor can be unrestricted up, stop. Won't cause temperature rise up, motor current increases.───電機可無限制地起、停。不會造成電機溫升增高，電流增大。
Parametric variation of induction motor for electric vehicles will result in fluctuation of motor current and torque.───電動車輛的變參數感應電動機將導致在電機電流和扭矩的波動。
The effects of vari-speed milling on vibration suppression along with the fluctuation of motor current are discussed in this paper.───通過試驗考證了變速銑削的減振效果和機床電機電流的波動幅度。
In a drive system of power transistor inverter-motor, not only can it be used in fine control of motor current waveform, phase, amplitude and frequency, but can also be used to sense, fault current.
The results show that motor current can be used to on-line monitor tool condition when turning.
For the oscillator of caster, the change in motor current can inflect the change in friction between billet and mould under a certain condition.