mould plate的意思

mould plate中文翻譯：

[塑料]模板，[木]模型板

相似詞語短語

mould───n.模具，鑄模；（人的）個性，類型；霉，霉菌；耕作土壤，腐殖土；n.(Mould)（美、愛、英）莫爾德（人名）；v.（用模具）澆鑄，塑造；對……施加影響；將…塑造成；緊貼于，吻合（輪廓）；使長霉

mould release───分型粉

mould engineer───模具工程師

bepower mould───bepower模具

plate───n.碟；金屬板；金屬牌；感光底片；vt.電鍍；給…裝甲；n.(Plate)人名；(英、德、俄、西、意、瑞典)普拉特

injection mould───注塑模具；注射模

tie plate───系板；連接板；鋼軌墊板

excussion plate───篩板

needle plate───針板；導針板

雙語使用場景

Finally, the mixed control is discussed and the corresponding mould plate is proposed.───最后還討論了混合控制方式，并提出了相應的模板。

This artical presents the productive technology and formulae of urea-formaldehyde resin used in bamboo mould plate.───本文對竹膠板模板用脲醛樹脂膠的生產工藝和配方試驗研究做了介紹。

The mould plate and ejector grid system is shown in chain-dotted lines in the cross-sectional view.───模板和頂料格架系統在剖面圖上以點劃線表示。

The problem associated with this particular gate design is with respect to the machining of the tapering curved orifice in the mould plate.───和這種特殊澆口設計相關的問題是逐漸變細的曲線孔在模板上的加工。

We stated previously that the ejector grid must provide adequate support for the mould plate.───我們前面已經說明頂料系統必須對模板提供足夠的支撐。

Further movement of the moving mould plate actuates the stripper plate and the moulding is ejected.───動模板進一步的運動帶動推板，使得塑件頂出。

or at least one mould plate (3) serves as a dispensable mould plate of the mould framework element;───或者至少一塊模板（3）為充當模殼構件部件的一次性模板；

The Design and Application of the Movable Steel Mould Plate used in the Tunnels with Outsized Sections───特大斷面隧洞鋼模臺車的設計和應用

Construction of Reinforced Concrete Structure Mould Plate with Curved Shape Poured on Site───曲面體現澆鋼筋混凝土結構模板施工

英語使用場景

This distance can be minimized, however, by sinking the sprue bush deep into the mould plate assembly as illustrated, though Ibis necessitates using a special extension nozzle.

The ejector grid is that part of the mould which supports the mould plate and provides a space into which the ejector plate assembly can be fitted and operated.

This artical presents the productive technology and formulae of urea-formaldehyde resin used in bamboo mould plate.

On the basis of Nickel mould plate fabricated by melting photoresist and electroforming PMMA cylindrical microlens arrays are fabricated by the replication technology of static casting plastic.

Note that die length of ejector pin contact with the mould plate is kept to a minimum by incorporating a clearance diameter hole in the mould plate.