青年中文internal friction的意思
internal friction中文翻譯：
[力]內摩擦；[材]內耗
friction───n.摩擦，[力]摩擦力
internal───n.內臟；內部特征；adj.內部的；體內的；（機構）內部的；國內的；本身的；內心的；（大學生）本校生的
friction factor───[力]摩擦因子；摩擦率；摩擦率，摩擦因數
palp friction───觸須摩擦
internal storage───內存（儲器）; 內存儲器；[計]內部存儲器
friction factors───阻力系數；[力]摩擦因子；摩擦率
internal gear───[機]內齒輪
fluid friction───[流]流體摩擦；鈴摩擦
internal control───[審計]內部控制；內控；內部控制，內部管理
analogy between internal friction increment and overstress due to strain-rate sensitivity is clarified.───由于應變率敏感性所引起的內耗增量和過應力的類比性。
These findings improve the understanding of the mechanism of GB internal friction.───這些發現加深了對晶界內耗機制的認識。
usual internal friction instrument is low-frequency mechanical relaxation instrument.───通常的內耗儀，應為低頻力學弛豫譜儀。
Determination of the yield strength of nuclear reactor pressure vessel steels by means of amplitude-dependent internal friction.───通過隨振幅變化而變化的內磨擦測定核反應堆壓力容器鋼屈服強度…[中國核科技信息與經濟研究院]。
The internal friction coefficients is deduced from the law of Maxwell distribution of velocities and distribution of mean-free path.───根據麥克斯韋速率分布和自由程分布推導出內摩擦系數。
All internal friction harmful to the War of Resistance must be sternly checked.───任何不利于抗戰的內部磨擦，都必須用嚴正的態度加以制止。
When the car wreck plowed into each other, - there was internal friction-- - no external friction-- and that took out kinetic energy.───車輛殘骸相互撞入，是有內部摩擦的-，但沒有外部摩擦-，這是損耗動能的。
Soil resistance and pastes cohesion and internal friction angle, is the two indicators which evaluate the performance of soil shear.───土壤抗剪黏聚力和內摩擦角，是評價土壤抗剪性能的兩項指標。
internal friction angle showed the largest evergreen broad-leaved forest, temperate coniferous forest minimal.───內摩擦角表現為常綠闊葉林最大，溫性針葉林最小。
The influences of the angle of internal friction, the angle of wall friction to the direction of principal strain rate are analyzed.
Young's modulus and internal friction angle have great effect on base bearing capacity, but cohesive strength have little effect on it.
Internal friction studies reveal that in steels and their decarburized alloys as well as non-ferrous alloys, the early stage effect of the bainitic transformation is the nucleation process of bainite.
In either case the internal friction is found to be proportional to the first and second power of (1-S), where is the degree of long range order.
Two internal friction peaks were found in pure rhombohedral PZT73 ceramics.
The cohesion and angle of internal friction of rock reduce considerably after unloading confining pressure; the reduction is more obvious especially with water pressure.
The analogy between internal friction increment and overstress due to strain-rate sensitivity is clarified.
Cohesion and angle of internal friction decrease along with the broadening of water content and the better linear relation exists in the moistening process.
Internal friction angle has a strong nonlinear relation with moisture state related saturation and a weak nonlinear relation with density state related saturation respectively.