maximum stress的意思

maximum stress中文翻譯：

[力]最大應力

相似詞語短語

maximum───adj.最高的；最多的；最大極限的；n.[數]極大，最大限度；最大量

stress───n.壓力；強調；緊張；重要性；重讀；vt.強調；使緊張；加壓力于；用重音讀；n.(Stress)人名；(意)斯特雷斯

maximum power───[化] 最高功率；[電]最大功率；最高功率

absolute maximum───最大絕對值

maximum height───最大高度

alternating stress mean stress───交變應力平均應力

shear stress───[力]剪應力；[力]剪切應力；剪應力; 切變應力; 切應力; 粘性摩擦應力

maximum drive───最大驅動力

financial stress───資金緊張；財務壓力

雙語使用場景

However, this method can be very useful for a simple identification of maximum stress areas.───不過，這個方法可以非常有用的一個簡單的識別的最大應力區。

The results showed that the maximum stress was located in the ground circle of the radome.───結果表明受風載荷的雷達罩的最大應力發生在截球底座的邊界上。

The fatigue life was linear to the logarithmic maximum stress.───疲勞壽命與最大應力近似呈對數線性關系。

The analysis shows the maximum stress concentration coefficient of this tangential nozzle is smaller than that of its radial counterpart.───計算結果表明，該切向接管的最大應力集中系數低于相同尺寸徑向接管的最大應力集中系數。

The alternation of the maximum stress region between the internal and external tube wall could led to local fatigue.───應力最大區域交替出現在傳熱管的內外管壁上，易導致傳熱管局部疲勞失效；

The maximum stress in slab surface increases with decreasing the taper ratio of crystallizer, and with increasing the slab width.───隨著結晶器錐度減小和連鑄坯寬度的增加，連鑄坯表層最大應力增加；

Results show that the position where the maximum stress happens in FEA and the actual rupture position are the same.───計算結果顯示，結構中應力響應最大值發生在篩箱短橫梁處，與結構實際斷裂位置一致。

It may solve the problems of maximum stress and maximum deformation of cantilever beams with variable cross section under arbitrary loads.───本文提供了一種求解變截面懸臂梁在任意載荷作用下最大正應力及最大變形的方法。

The results show that the maximum stress usually appears near the position when the tooth bears most of the load.───分析結果表明，齒根應力最大值一般出現在輪齒承受最大載荷的時刻附近。

英語使用場景

The maximum stress is on the transformer core, and the glass support plate also undertakes considerable stresses.

After 59 times of iterative computation, the optimized structure parameters were obtained. The maximum stress decreased by 33.5%.

In this paper, the maximum stress of the surface plate glass in container impacted inhorizonal direction is determined by theoretical analysis and experiments.

The maximum stress point moves to compressive stress, depended on the experimental data, when negative rake angle substituted for positive one and other cutting conditions kept fixed.

The elastic limit is the maximum stress for which the material acts elastically .

Thee elastic limit is the maximum stress for which the material acts elastically.

Fatigue limit. For fatigue, the maximum stress amplitude level below which a material can endure an essentially infinite number of stress cycles and not fail.

The results showed that the maximum stress was located in the ground circle of the radome.

Under the same load, the curve that the maximum stress of aluminum honeycomb core varies with the subtense distance and depth of honeycomb core has been gained.