residual deformation的意思

residual deformation中文翻譯：

殘余變形；殘留變形

相似詞語短語

deformation───n.變形

residual───adj.（數量）剩余的；（物質狀態在成因消失后）剩余的，殘留的；（實驗誤差）舍去的，殘差的；（土壤）殘余的；n.（Residual）（美、阿根廷）瑞斯卓爾（人名）；n.剩余物，殘渣；殘差，剩余誤差；（付給表演者的）復播追加酬金；（地質）殘丘，蝕余山；（新車購入一定時間后的）轉售值

plastic deformation───塑性變形，柔性變形；[力]塑性變形，塑性應變

ductile deformation───延性變形；柔性變形

deformation gradient───[力]變形梯度

deformation retraction───形變收縮

residual definition───殘差定義

deformation definition───變形定義

elastic deformation───彈性變形；[力]彈性形變

雙語使用場景

The article introduces a repair welding technology which prevents the worn axis from residual deformation and assures the repaired axis normally running.───介紹了一種防止磨損軸在焊補過程中出現殘余變形，以保證修復軸正常運轉的軸磨損無變形焊補工藝。

Maximum deformation and residual deformation are given by solving the systems of simultaneous equations.───通過求解建立的平衡方程組，給出了平臺的最大變形和殘余變形。

method of energy difference between elastic deformation and elastic-recovery deformation is developed to determine the residual deformation energy.───提出用彈性變形能與彈復變形能的差值來確定殘留變形能的方法。

The foundation stability and residual deformation must be evaluated before building life or service facilities above old mine goaf.───在老采空區上方建設生活或服務設施時，必須對老采空區上方地基穩定性和殘余變形情況進行評價和預測。

Rubber or plastics based materials. Determination of residual deformation. Test without stress.───橡膠或塑料微孔制品.永久變形的測定.無負荷試驗

Based on the test results, the mechanism of the influences of reinforcement on the residual deformation is proposed tentatively.───還根據試驗結果，初步探討了加筋對動殘余變形影響的機理。

The measures of control welding residual deformation.───控制焊接殘余變形的措施。

In the first cycle, the residual deformation is large, and the loading-unloading curve forms a horn-shaped curve.───卸載曲線與下一個循環的加載曲線通常也不重合，但會形成閉合環路。

After the ultimate load, the beams still hold a relative high level of capacity to bear load and develop residual deformation.───在極限荷載之后，梁仍可以維持較高的承載能力繼續承載并發展殘余變形。

英語使用場景

In the first cycle, the residual deformation is large, and the loading-unloading curve forms a horn-shaped curve.

The results show that: with the initial principal stress direction angle increases, the axial residual deformation from the compression state gradually transits to the elongation.

Maximum deformation and residual deformation are given by solving the systems of simultaneous equations.