middle temperature的意思

middle temperature中文翻譯：

中間溫度

相似詞語短語

temperature───n.溫度；體溫；氣溫；發燒

middle───n.中間，中央；腰部；adj.中間的，中部的；中級的，中等的

critical temperature───[物][電子]臨界溫度；n.臨界溫度

temperature outside───室外溫度

temperature rise───[電]溫升；溫度上升；溫度上升，溫升，升溫

constant temperature───[熱]恒溫；定溫；等溫；等溫，恒溫

fluctuating temperature───波動溫度；脈動溫度；脈動溫度，波動溫度

low temperature───低溫，低溫度；[物]低溫

annealing temperature───[機]退火溫度；退火點；退火點，退火溫度

雙語使用場景

desorbed hydrocarbon technology introduced in this paper makes this part of hydrocarbons desorbed under low and middle temperature.───本文介紹的熱釋烴技術，通過在中低溫度下熱脫的方法解吸硅酸鹽礦物中吸留的烴類。

In general, the water heater in the middle temperature state is the most energy-efficient.───熱水器工作在中溫狀態是最節能的。

Key problems on energy saving of high emissivity coating at middle temperature are discussed.───本文論述高發射率涂料在中溫下使用，節能的若干關鍵問題。

This paper focused on describing planning research of power generation from middle temperature flue gas waste heat in Jiao Zuo cement plant.───本文論述了焦作水泥廠中溫煙氣余熱發電方案研究。

Study of middle temperature phosphating process───中溫磷化工藝研究

Applications of High Corrosion Resistance Zinc-Calcium Middle Temperature Phosphating on Rolling Stock───高耐蝕鋅鈣中溫磷化在機車車輛的應用

New Application Technology of Chemical Nickel phosphorus Plating from alkaline bath at Middle Temperature───中溫堿性化學鍍鎳磷實用新工藝研究

Research and application of special effective middle temperature phosphating───特效中溫磷化工藝的開發及應用

Instantaneous Sterilization Craft and Aseptic Middle Temperature Filling of Beer───啤酒瞬時殺菌工藝及無菌中溫灌裝

英語使用場景

Key problems on energy saving of high emissivity coating at middle temperature are discussed.

The deposit middle temperature meteoric hydrothermal ore deposit.

A test of lower middle temperature blackening on steel part was introduced.

We consider that the method of phosphatizing in room-temperature is successful, which can replace that in high and middle temperature.

The middle temperature has improved deposition efficiency and is benefit for reducing burning of alloys.

An one-component adhesive curing middle temperature is composed of epoxy rein, incubative curing agent, accelerant and compounded filler, which can be used in SMT and LCD.