stress ratio的意思

stress ratio中文翻譯：

[力]應力比

相似詞語短語

stress───n.壓力；強調；緊張；重要性；重讀；vt.強調；使緊張；加壓力于；用重音讀；n.(Stress)人名；(意)斯特雷斯

ratio───n.比率，比例

alternating stress mean stress───交變應力平均應力

variation ratio───異眾比率；變異比率；變速比，變速范圍

shear stress───[力]剪應力；[力]剪切應力；剪應力; 切變應力; 切應力; 粘性摩擦應力

financial stress───資金緊張；財務壓力

residual stress───[力]剩余應力；殘余應力

M stress───M應力

proof stress───[力]彈性極限應力；試驗應力；耐力；彈性極限應力，耐力，試驗應力; 屈服點

雙語使用場景

The influence of consolidation stress ratio on damping ratio is not distinct.───但固結應力比與有效圍壓應力對阻尼比之影響則較不明顯。

With the increase of the stress ratio r, the threshold decreased.───隨著應力比的增加，門檻值下降。

get valuable results about the effect of the stress ratio and residual stress on fatigue crack growth.───應力比，殘余應力對疲勞裂紋擴展的影響方面獲得了有價值的成果。

For the case of fatigue loading: (1)For a given stress ratio, the specimen seeks the SDS for the largest S_(max) to which it is subjected.───對疲勞載荷作用的情況：（1）對于給定的應力比R，試樣會趨于與它所承受的S_（max）最大值相應的SDS狀態。

Short-pile axial force increased, pile-soil stress ratio and the pile load distribution ratio did not change significantly.───柔性樁軸力有所增加，樁土應力比與樁的荷載分擔比變化不明顯。

Flexible pile axial force increases, pile-soil stress ratio and the pile load distribution ratio did not change significantly. 6.───柔性樁軸力增加，樁土應力比與樁的荷載分擔比變化不明顯。

However, the propagating rate of weld metal will decrease with the increase in stress ratio under dead load and constant maximum loa. . .───在靜載和最大載荷一定的情況下，隨應力比增大，焊縫的擴展速率降低。

It also can be observed that the dynamic strength decreases significantly as radial cyclic stress ratio increases.───隨著徑向循環應力比的增加，土體的動強度降低。

A modified model is presented by assuming that the relation between the stress ratio and shear strain on the SMP is hyperbolic.───通過假定空間滑動面上的應力比與剪應變之間符合雙曲線關系予以修正。

英語使用場景

In addition, cyclic stress ratio and number of cyclics have remarkable effects on vertical deformation of cement-soil pile composite foundation.

As the length of upper column part increases under the same condition, the end resistance under varied cross-section decreases, but the column-soil stress ratio increases.

The traditional dilatancy equation of Cam-clay model was modified and the relativity between the phase transformation stress ratio and initial effective pressure was considered.

The iterative formulas (one load condition) of the elastic energy of structure and the stress ratio of each member are given, and its properties are also discussed.

The relation between stress ratio and span centre deflection is linear, and when the stress ratio is large, the increase of mid-span deflection by cycle index is small.

Both the numerical analysis and experimental data show that the fatigue crack propagation rate is insensitive to the stress ratio for plain stress thin specimens.

When the failure criterion is decided, the limit accumulate energy dissipation can be fitted by a formula which includes the average stress, deviator stress ratio and cyclic axial stress.

It includes the concept of stress correction coefficient, a new method to determine the stress concentration factor of mortise of a disk and a new method for correcting the stress ratio.

The smaller the stress ratio is, the larger the increase of span centre deflection by cycle index is.