point operation的意思

point operation中文翻譯：

[計]點運算

相似詞語短語

operation───n.操作；經營；[外科]手術；[數][計]運算

invalid floating point operation───浮點運算無效

commercial operation───[經] 商業經營

strabismus operation───[醫]斜視手術

operation management───運營管理；經營管理；操作管理

heart operation───心臟手術

discontinued operation───[經] 停（中）止經營；停止經營

operation manual───操作指南；操作手冊；[計] 操作指南，操作手冊; [化] 操作手冊

transplant operation───器官移植術

雙語使用場景

A floating point operation at the RPC server caused a divide by zero.───RPC服務器上的一次浮點操作引起除數為零。

Any floating-point operation like addition or multiplication is achieved in a few discrete steps.───任何浮點操作，例如加法和乘法，都可以通過幾個步驟來實現。

basic subroutines such as character and graphic point operation were presented in this part.───介紹字符處理、象點處理等基本子程序。

If the result of a floating- point operation is too small for the destination format , the result of the operation is zero .───如果浮點運算的結果對于目標格式來說太小，則運算的結果為零。

In the past, fixing-point operation is usually used in gate circuits whose calculation precision is limited.───過去用門電路進行各種運算通常為定點運算，但其計算精度有限。

Each floating point operation that combines two values will finish by rounding off the result to the nearest representable value.───每個結合兩個浮點值的浮點操作都會將完成時的結果四舍五入到可被精確表示的那一位。

If a floating-point operation is invalid, the result of the operation is NaN.───如果浮點運算無效，則運算的結果為NaN。

If the magnitude of the result of a floating-point operation is too large for the destination format, the result of the operation is───如果浮點運算結果的數值對于目標格式來說太大，則運算的結果為

Instead, in exceptional situations the result of a floating-point operation is zero, infinity, or NaN, as described below───在異常情況下，浮點運算的結果為零、無窮或NaN，如下所述

英語使用場景

A physical processor is organized as different execution units at the hardware level, for example, fixed point and floating point operation units.

A floating - point operation at the RPC server caused a division by zero.

The operation consume most time is multiplication of a point on the elliptic curve with an integer in the system, which was called multiple point operation.

The basic subroutines such as character and graphic point operation were presented in this part.

This paper introduces a computation method of trigonometric functions and inverse trigonometric functions in microprocessor by usr of combination binary fixed point operation with look-up table.

Since the system mainly depends on multiple point operation, so the cost of executing the system depends mostly on the cost of the multiple points operation.

A floating point operation at the RPC server caused a divide by zero.

Each floating point operation that combines two values will finish by rounding off the result to the nearest representable value.