青年中文青年中文

premature failure的意思

premature failure中文翻譯:

[經]過早失效;過早破壞

相似詞語短語

premature───n.早產兒;過早發生的事物;adj.早產的;不成熟的;比預期早的

failure───n.失敗; 失敗的事/人; 沒做到; 故障; 破產; 歉收;n.失敗;故障;失敗者;破產

premature baby───早產兒

premature death───[醫]早產兒死亡;過早死亡;早逝

business failure───經營失敗;[經管]企業破產;[經管]企業倒閉

failure notice───系統退信;發送失敗通知

boot failure───自舉失敗;啟動故障

mechanical failure───[機]機械故障

brittle failure───脆斷,脆性破壞;脆性破壞;脆性疲勞;脆性失敗

雙語使用場景

Corrosion of reinforcing rebar is the main reason of premature failure of reinforced concrete structures.───混凝土中鋼筋的腐蝕是鋼筋混凝土建筑過早損壞的主要原因。

premature failure in VRLA battery mainly attributed to the inner water loss.───鉛酸蓄電池內部失水是引起電池早期失效的主要原因。

In this paper reasons of premature failure of gear teeth of coal mining machinery are analyzed.───本文分析了煤礦機械齒輪早期斷齒的原因。

Premature failure of the usually long-life, low-energy light sources may also be occurring.───使用壽命短,節能燈的光源會經常引起事故。

It should also be noted that CroMo frames will eventually rust leading to premature failure.───還應當指出,CroMo框架將最終導致過早衰竭生銹。

Premature failure of reinforced concrete structures are mostly caused by the corrosion of rebars embedded in the concrete.───鋼筋混凝土結構的過早失效大多是由于其中的鋼筋腐蝕所致。

Frequent or premature failure of the packing.───填料經常性更換失敗。

This can result in premature failure of sealing membrane.───否則可能導致密封膜過早破壞。

Premature Failure Analysis for Bituminous Pavement of Expressway in South Rainy Region and Its Countermeasures───南方多雨地區高速公路瀝青路面早期破壞的成因分析及對策

英語使用場景

Premature failure of the usually long-life, low-energy light sources may also be occurring.

If you use unleaded in an engine not designed for it then premature failure of the exhaust valve seats will result.

The premature failure modes of firebrick forming dies made of steel 10 and its failure reason are analyzed. The possibility of using rare earth Mg ductile iron to replace steel 10 was expounded.

On the basis of these, a new design concept and process of group welding are presented to solve the Premature failure of the cross beam.

The rubber boot is to stop ingress of dirt, etc. into the splines, causing premature failure.

The results show that the maximum achievable repeater spacing is 17km over that calculated using a conventional worst-case design approach for a premature failure rate of 0.1%.