pressure setting的意思

pressure setting中文翻譯：

壓力整定；壓力設定；壓力調整

相似詞語短語

setting───n.環境；安裝；布置；[天]沉落；v.放置；沉沒；使…處于某位置（set的ing形式）

pressure───vt.迫使；密封；使……增壓；n.壓力；壓迫，[物]壓強

speech setting───語音設置

brightness setting───亮度設置

setting off───使爆炸，出發; 斷流；使爆炸；斷流

temp setting───調溫（=temperatureset）；溫度調節

factory setting───工廠設定；出廠設置

heat setting───熱定型；[紡]熱定形

setting up───設立；裝置；調定，安裝; 刷毛; 汽蒸

雙語使用場景

could be equipped by suitable actuator and control value according to different pressure setting range.───可根據不同的壓力設定范圍而選配合適的執行器與控制閥組成調壓閥。

it this way: At a low pressure setting everyone is wearing roller skates, which can change direction very easily.───這樣看待問題：當交通壓力小的時候，行人就像穿溜冰鞋行走，很容易改變方向。

The horsepower available and the lowest pressure rating of any component limit the pressure setting.───可用的馬力和任何部件的最低壓力限制了壓力的設置。

Selectable spring ranges to allow for accurate , easy to adjust pressure setting .───可選擇彈簧作用范圍，以便更精確、更容易地調節壓力設置。

Pilot valve pressure setting on the adjustable Enlarge the small set pressure, you can set the flow of a small flat tone.───導閥上的設定壓差可調，調大調小設定壓差，可以調大調小設定流量。

The pressure setting ofthe pressure-relief valve must not be less than 75%, nor more than100% of the minimum test pressure of the cylinder.───降低壓力閥的壓力設定值不能小于鋼瓶的最小測試壓力的75%，也不能大于它的100%。

This insufflator automatically regulates the flow rate to maintain an abdominal pressure equal to the pressure setting.───本注氣器可自動校對流速，以使腹部壓力不偏離預先設定。

The amount of lag is dependent on the size of the turbo s used and the pressure setting.───滯后的數量取決于大小的增壓器使用和壓力設置。

The 116-52 responds by opening at a preset low pressure setting, allowing for quick relief of the returning high pressure wave.───116-52通過開啟預置低壓設置點來做出響應，使其迅速釋放返回的高壓波。

英語使用場景

This insufflator automatically regulates the flow rate to maintain an abdominal pressure equal to the pressure setting.

Preventive measures for excursion of pressure setting point are also mentioned.

This insufflator automatically regulates the flow rate to maintain an abdominal pressure pressure setting.

Note: a pressure gauge downstream to adjust and verify the pressure setting.