steering knuckle的意思

steering knuckle中文翻譯：

轉向關節

相似詞語短語

steering───n.操縱；指導；掌舵；v.駕駛；掌舵（steer的ing形式）

knuckle cracking───[醫]指節斷裂；折手指

moose knuckle───駝鹿關節

steering wheel───n.方向盤; 駕駛盤；方向盤；[車輛]駕駛盤；舵輪

steering committee───n.籌劃指導委員會

knuckle dusters───關節撣子

steering columns───n.（車輛的）轉向柱，方向盤柱；n.駕駛桿( steering column的名詞復數 )

steering locked───轉向鎖定

knuckle sandwich───n.對準嘴的一拳

雙語使用場景

Thus, the steering knuckle, spindle, wheels, and tires turn to one side, causing the car to turn.───這樣，轉向節、轉向節軸端、車輪和輪胎都會向一側旋轉，汽車實現轉向。

This movement is produced by gearing and linkage between the steering wheel in front of the driver and the steering knuckle.───這一運動是由裝在駕駛員前面的轉向盤與轉向節之間的轉向器和連桿裝置來共同完成的。

The results show that the thermomechanical treatment can improve the quality of the automobile steering knuckle.───結果表明，鍛造余熱淬火工藝對汽車轉向節質量有明顯改善。

The steering-knuckle arm, attached to the front wheels, are therefore forced to swing the wheels to the right or left on their pivots.───于是，與前輪相連的轉向節臂使車輪在其軸線上左右轉動。

The trike frame should now be nearing completion and only requires the installation of the steering knuckle mounting plates to be complete.───該三輪車框架現在應該已接近完成，只需要安裝指導安裝板的關節完整。

Assuming that the Knuckle Face Plates have been fabricated (and welded to the frame), the steering knuckle assembly can now be assembled.───假設豬腳面板已制造（和焊接到框架）中，轉向節大會，現在可以進行組裝。

The last modification required to the brake faceplate, is making the plate flush with the steering knuckle faceplate.───最后修改面板所需的制動，轉向是使板與關節沖洗面板中刪除。

A feasible process scheme was made for forming the steering knuckle of a truck based on a technological analysis on the forging of the part.───通過對卡車轉向節鍛件的工藝分析，制定了合理的工藝方案。

These include the fabrication of the Derailleur Cable Stop, and drilling the holes for both steering knuckle levels.───這些措施包括停止生產的變速器電纜，鉆兩個孔，關節指導的水平。

英語使用場景

Remove the steering knuckle from the strut.

A worn steering knuckle arm on a motor vehicle may cause heavier steering operation, the reasons are studied in this paper according to the steering trapezium principle.

Place the entire steering knuckle assembly in a vise and re - drill using the # Q drill bit.

Route sensor wire from steering knuckle to fender panel.

Lots of well-forged, normatively heat-treated, and elaborately-processed steering knuckle arms, pitman arm, idler arm pendulum lever etc, can be used widely as parts of various types of truck and car.

The steering knuckle then supported through Ball joints, by upper and lower control arms which are attached to the car frame.

Sentencedict.com try its best to gather and create good sentences.

With the steering gear meshing steering rack level arrangement, the both sides with change the steering knuckle tie rod through a ball place to be connected.

A steering knuckle is the key component in cars, which needs high requirements in dimensional accuracy and product quality.